Its time to clean out the garage to make room for new car parts. All components are in good condition unless noted. Let me know if you need more details or additional pictures.
All the components listed below are before adding for shipping. I will be at the VIR runoffs on from September 30, Saturday and October 1st Sunday and can deliver for free.
All aluminum scale set up platform $600 or BO
97 VD FF nose assembly (red and black) $100
99 VD FF or newer damper cover (gray) new never used $100
99 VD FC damper cover (black) $100
(2) 97VD FF crush box $75 for the one on the right (silver)and $50 for the one on the left (black). The left one is sound but a bit rough arround the edges.
97VD left and right radiator ducts $100 for the set
VD Honda factory exhaust pipe , never used $125
(4) AP LD 20 calipers. I took them off the car during a ground up re build, so I don’t know the status of them. I would install new seals in them. The pistons look good $50 for all 4
LD200 input shaft, I believe was for a Zetec engine. It measures 25.5” long, both splines have 23 teeth. Small spline OD .779” large spline 1.014 OD $75
1 VD FF Pansport rim it has some blemishes on the outer flange and on the inside of the rim. $50
Best of luck to everyone at the Runnoffs,
Chris