Anybody have a recommendation for a new clutch slave cylinder? The actuating arm looks stock.
Thanks,
Garry
Anybody have a recommendation for a new clutch slave cylinder? The actuating arm looks stock.
Thanks,
Garry
I have used both Wilwood and CNC with very good results.
I have one EMPI chinese copy in new spares.
It was cheap but unknown quality.
I was just going to go for the Wilwood but it gets terrible reviews. I was looking at Howe Racing. It uses a thick rubber seal instead of an O ring.
Garry
I have 4 CNC left in stock
Dietmar
Quixoteracing.com
The Protoform and Vortech Vees both spec'd the CNC.
If Dietmar has them in stock thats your best recommendation.
My personal experience was that these are cheap and disposable. So while one could argue that you can shop for the best one, I would just order 2 of the cheapest I could find. They get subjected to engine oil, exhaust heat, misalignment issues, crash damage, etc. When one gives problem, put on your spare and order another spare.
My supplier was Bicknell Racing Products.
Greg Rice, RICERACEPREP.com
F1600 Arrive-N-Drive for FRP and SCCA, FC SCCA also. Including Runoffs
2020 & 2022 F1600 Champion, 2020 SCCA FF Champion, 2021 SCCA FC Champion,
2016 F2000 Champion, Follow RiceRacePrep on Instagram.
There are currently 1 users browsing this thread. (0 members and 1 guests)