Results 1 to 3 of 3
  1. #1
    Classifieds Super License
    Join Date
    08.27.05
    Location
    Prescott, AZ
    Posts
    323
    Liked: 21

    Default APR molded wing elements

    These do not have wavy surfaces like hot wire cut wing elements often do.
    These are high quality molded elements that are hollow (no foam) inside except for thin carbon fiber strengthening ribs.
    They can be used for low front wings and are very tough.
    Can usually always survive high speed direct cone hits. I cut a cone in half at 65 Mph with my old front wing built like this.

    APR molded carbon fiber wing elements.
    Priced approximately 40% of new
    .
    Can have 4” cord APR flap added to make the popular 2 element combination rear wing assembly as used on production or modified cars
    Quality highly polished finish, strong construction
    Nice sharp thin well defined trailing edges.

    All are 10” cord with profile similar to high lift Eppler 422.
    Hollow construction with thin internal longitudinal stiffening ribs.
    2 female threaded mounting inserts each end

    2 Brand new, Carbon Fiber, 54.5” long
    10" cord
    $350 each.
    5 lbs. 12-5/8 oz. each
    Pictures have dust smudges, wing surfaces are very nice

    These could be trimmed easily to 43.307" wide to form a 2 element lower tier on a B-Modified formula car rear wing.
    You would use these new end caps below after trimming the element span if the old end caps cannot be re used (usually they are)

    2 new carbon fiber end plates
    with threaded inserts if lengths of any of the above elements need to be changed in span and one is not able to completely clean up and reuse the original inserts. $20 each


    1 Brand new Carbon Fiber 56.5” long
    10" cord
    $375
    6 lbs.

    The last picture shows how a typical bottom mount is made. Just 2 curved pieces of aluminum using 3/16" rivets up into the element.
    Or they can be supported only by the end plates.
    Attached Images Attached Images
    Last edited by B17overhead; 06.14.24 at 1:22 PM.

  2. #2
    Contributing Member
    Join Date
    10.08.06
    Location
    San Jose, Ca
    Posts
    791
    Liked: 110

    Default

    So these are designed to be end mounted, not center?

  3. #3
    Classifieds Super License
    Join Date
    08.27.05
    Location
    Prescott, AZ
    Posts
    323
    Liked: 21

    Default

    Quote Originally Posted by 10rmotor View Post
    So these are designed to be end mounted, not center?
    Either way.
    I had a 4-element assembly where some elements just like this were supported by their ends and then one element had a lower support. The other elements' loads came back to it through the endplates.

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social