Fresh 1600 Kent Engine

Just assembled by Rex Gunning:

Freshly Machined Block
New Rings
New Bearings
Freshly turned and polished original crank
New Cam and Lifters
Hepolite Pistons
Rebuilt Head - Iron - I can substitute an aluminum head for an additional $800
Upgraded Aluminum Rocker Supports
Profiled Rockers to maximize legal lift
Blueprinted Bosch Distributor
Blueprinted Pace Oil Pump
Tach Drive
Flywheel Machined to legal minimum
Rotating assembly balanced
Pistons/Rods/Pins - reduced to minimums
Big End/Small Ends of rods balanced
Steel Pan
New Fuel Pump
Ready to bolt in and race

Anyone that knows Rex Gunning knows his attention to detail.

$3800 - I can deliver within 150 miles of Cincinnati or make arrangements.

Is this an upgraded Kent Engine?

It is considered an uprated Kent engine with the GT cam, later model block, pistons, head. I think that is what you mean. If not let me know.

Joe

Is this a cast iron crank and how many hours on crank

Is this a cast iron head

Yes all FF cranks are cast, the latest iteration from SCCA is just an updated casting. This is one of the original castings that was magnafluxed, turned and polished. Number of hours I can't really say as I got it with the spares that came with my Swift and I sent it out to the crank shop to be prepped.

Head is a cast iron head, I do have an aluminum head that I could sub for the iron head for an additional $800.

Thanks

Joe

Hello Joe,

Forgive me if Im asking the same question again Im just trying to learn as much as possible about your enging.

So the crank is a Ford crank and not a SCAT crank ; is this correct?
How much has been turnrd off the crank, what size main and rod bearings?
Have the cylinders been bored, How much
How much matl has been remover from valve seats
Has the engine been on the dyno, what did it produce?

Yes standard Ford Crank not the new Scat/SCCA Crank
Turned 10/10
Cylinders are standard as they were sleeved.
Valve seats are fresh with only a single cut on them (i.e. they are not sunk in the head)
No dyno - if you would like it dyno'd we can put it on the dyno for $650

Sold - Thanks