Have you ever tried to regrease them? I put some redline CV2 in a syringe with a smallish needle and sneak it under the inner diameter of the seal in
10rmotor 05.20.24, 9:13 AMBasically, yes. Heat to remove, heat to install.
Once the cast upright is heated, the bearing might fall into place without the need of a press.
About UsSince 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track. |
Identifying bearings
I obviously never found that page, but I don't think TL20H has ever been used in any context with this engine that I can remember, NE series maybe, but
Rick Kirchner 05.20.24, 10:32 AM