I used one of the high temp JB Weld products to solve the exact same problem. I had low expectations, but 10 years later it’s still there.
Hawke 06.01.24, 4:47 PMLooking for a Swift DB1 roller (only). May consider other rollers from the same general era but prefer a DB1.
Let me know what you have.
Please post pin drive diameter, pin spacing center to center and the center hole diameter.
Thanks Thomas
Brazing it up will work. Pre-heat the head in an over or something. Just make sure the surfaces are clean on both sides if you can.
Earley Motorsports 06.01.24, 3:19 PM
About UsSince 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track. |
WTB: FC 8" rear wheel
Looking for an 8" rear, 12 spoke OZ for a 99+ Van Diemen.
Lotus7 06.01.24, 8:39 PMLet me know what you have, and a price.
thanks