I obviously never found that page, but I don't think TL20H has ever been used in any context with this engine that I can remember, NE series maybe, but
I probably owned nearly a dozen of these in the eighties
Have you ever tried to regrease them? I put some redline CV2 in a syringe with a smallish needle and sneak it under the inner diameter of the seal in
Worthwhile to measure the block bearing bore.
Basically, yes. Heat to remove, heat to install. Once the cast upright is heated, the bearing might fall into place without the need of a press.
Section Widget
Categories Widget (Show All)
Recent Articles
Recent Article Comments Widget
Identifying bearings
I obviously never found that page, but I don't think TL20H has ever been used in any context with this engine that I can remember, NE series maybe, but
Rick Kirchner 05.20.24, 10:32 AM