Have you ever tried to regrease them? I put some redline CV2 in a syringe with a smallish needle and sneak it under the inner diameter of the seal in
Worthwhile to measure the block bearing bore.
Basically, yes. Heat to remove, heat to install. Once the cast upright is heated, the bearing might fall into place without the need of a press.
While Scotty has my gearbox, I am spending a bit of time cleaning up the rear and doing a good inspection. The left rear upright bearing is starting to
The bearings and their specs are listed under the engine/s Model prefix TL20H, "Pinto" is more of a slang term If you click on each bearing
Section Widget
Categories Widget (Show All)
Recent Articles
Recent Article Comments Widget
Upright Bearing - Time to Replace?
Have you ever tried to regrease them? I put some redline CV2 in a syringe with a smallish needle and sneak it under the inner diameter of the seal in
10rmotor 05.20.24, 9:13 AM