1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    267,369
Page 1 of 126 1234511 ... LastLast
Threads 1 to 40 of 5009

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 183
    • Views: 295,231
    05.12.24, 3:40 PM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,984
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 41,126
    01.15.14, 9:36 AM Go to last post
  1. interesting...

    Started by Rick Kirchner, 05.26.24 8:56 PM
    • Replies: 0
    • Views: 83
    05.26.24, 8:56 PM Go to last post
  2. Replacement PFC rotors

    Started by R. Pare, 05.25.24 6:36 PM
    • Replies: 0
    • Views: 80
    05.25.24, 6:36 PM Go to last post
  3. Vd starter issue, grinding flywheel

    Started by redcar9, 03.25.24 9:11 PM
    2 Pages
    1 2
    • Replies: 43
    • Views: 3,234
    05.19.24, 10:08 AM Go to last post
  4. Rain tires illegal due to width

    Started by Bob Coury, 05.06.24 8:12 PM
    • Replies: 5
    • Views: 636
    05.08.24, 5:46 PM Go to last post
  5. MZR oil pump to replace MIA Elite pump

    Started by Redawgleader, 05.06.24 1:42 PM
    • Replies: 4
    • Views: 383
    05.07.24, 9:51 AM Go to last post
  6. Brake pad

    Started by f500racer, 04.30.24 8:13 AM
    • Replies: 9
    • Views: 665
    05.05.24, 11:22 AM Go to last post
  7. Fc water pump pulley grinding

    Started by redcar9, 04.28.24 2:24 PM
    • Replies: 19
    • Views: 1,413
    05.02.24, 12:24 AM Go to last post
  8. Eagles Canyon FC Gearing?

    Started by Phil Picard, 04.26.24 5:48 PM
    • Replies: 0
    • Views: 238
    04.26.24, 5:48 PM Go to last post
  9. Van diemen gear box oil leak

    Started by redcar9, 04.21.24 5:25 PM
    • Replies: 6
    • Views: 683
    04.22.24, 3:22 PM Go to last post
  10. RF99 Cockpit input...

    Started by speeddiemen, 04.16.24 5:39 PM
    • Replies: 10
    • Views: 948
    04.17.24, 2:24 PM Go to last post
  11. Pinto fuel pump

    Started by John Green, 04.03.24 4:20 PM
    • Replies: 19
    • Views: 923
    04.05.24, 3:31 PM Go to last post
  12. 2.0l pinto timing light

    Started by redcar9, 04.02.24 5:48 PM
    • Replies: 8
    • Views: 472
    04.03.24, 11:17 AM Go to last post
  13. ISO Van Diemen RF97 manual

    Started by Thrlskr, 04.04.23 9:16 PM
    • Replies: 4
    • Views: 1,415
    04.02.24, 10:28 PM Go to last post
  14. Pinto distributor wire

    Started by redcar9, 01.16.24 10:14 PM
    • Replies: 34
    • Views: 2,663
    04.02.24, 5:36 PM Go to last post
  15. Pinto 2.0 points and condenser source

    Started by John Green, 03.31.24 5:40 PM
    • Replies: 3
    • Views: 413
    04.01.24, 1:23 PM Go to last post
  16. Hewland 9 ratio change???

    Started by rorym, 05.06.10 5:29 AM
    • Replies: 28
    • Views: 9,016
    03.27.24, 4:17 PM Go to last post
  17. AP 4 puck disc

    Started by Rick Kirchner, 02.08.24 1:13 PM
    • Replies: 10
    • Views: 1,325
    03.26.24, 4:57 PM Go to last post
  18. Moved: Right Formula Racing is open for business!

    Started by oppermann, 03.26.24 2:48 PM
    •  
    •  
  19. 93 VD Upright dissassembly

    Started by Rspink2012, 03.26.24 8:58 AM
    • Replies: 0
    • Views: 226
    03.26.24, 8:58 AM Go to last post
  20. High oil pressure

    Started by John Green, 03.24.24 7:10 PM
    • Replies: 7
    • Views: 769
    03.25.24, 2:11 PM Go to last post
  21. Moved: Hoosier Bias Rain Tires 21.0x6.5-13W3

    Started by tmet07, 03.15.24 10:18 AM
    •  
    •  
  22. zetec crank picup

    Started by jimj11, 03.08.24 12:23 PM
    • Replies: 1
    • Views: 577
    03.11.24, 11:54 AM Go to last post
  23. Bead seat sizing

    Started by redcar9, 01.22.24 12:08 AM
    • Replies: 19
    • Views: 2,242
    03.04.24, 1:16 PM Go to last post
    • Replies: 0
    • Views: 395
    02.20.24, 3:38 PM Go to last post
  24. FC setup for VIR

    Started by Superjet800, 02.16.24 1:36 PM
    • Replies: 3
    • Views: 686
    02.20.24, 3:28 PM Go to last post
  25. Need an engine measurement

    Started by Rick Kirchner, 02.18.24 6:31 PM
    • Replies: 3
    • Views: 489
    02.19.24, 3:23 PM Go to last post
  26. How to check lube level in a Staffs box

    Started by Steve Demeter, 02.13.24 6:45 PM
    • Replies: 4
    • Views: 649
    02.14.24, 6:53 PM Go to last post
  27. studs

    Started by Rick Kirchner, 02.08.24 1:36 PM
    • Replies: 11
    • Views: 1,020
    02.10.24, 3:08 PM Go to last post
    • Replies: 0
    • Views: 273
    02.09.24, 7:54 PM Go to last post
  28. Convert blade rear roll bar to T-post

    Started by Lyngengr, 01.30.24 12:31 PM
    • Replies: 12
    • Views: 1,551
    02.09.24, 4:30 PM Go to last post
  29. Five Spoke OZ wheels

    Started by John Green, 01.25.24 6:22 PM
    • Replies: 2
    • Views: 458
    02.09.24, 3:43 PM Go to last post
  30. VW type Cv joints

    Started by Steve Demeter, 01.25.24 7:11 PM
    • Replies: 6
    • Views: 1,324
    02.01.24, 9:56 AM Go to last post
  31. Question about the Great Lakes CFC Group

    Started by Brian Graham, 01.21.24 10:23 AM
    • Replies: 2
    • Views: 450
    01.22.24, 11:02 AM Go to last post
    • Replies: 23
    • Views: 2,926
    01.21.24, 10:26 PM Go to last post
  32. Pinto piston rings

    Started by John Green, 01.04.24 11:46 AM
    • Replies: 2
    • Views: 648
    01.04.24, 6:47 PM Go to last post
  33. Snetterton Safety Device

    Started by JC86, 12.29.23 9:15 AM
    • Replies: 2
    • Views: 839
    12.29.23, 1:06 PM Go to last post
  34. Counter sink rivets

    Started by Hartley, 12.11.23 9:51 AM
    • Replies: 9
    • Views: 1,387
    12.24.23, 8:08 PM Go to last post
  35. Bsp- an- npt- male/female hell

    Started by John Green, 12.06.23 4:58 PM
    • Replies: 11
    • Views: 1,125
    12.07.23, 5:16 PM Go to last post
  36. Van Diemen clutch slave cylinder

    Started by Spengo, 03.03.23 8:07 PM
    • Replies: 38
    • Views: 5,650
    11.21.23, 7:29 PM Go to last post
  37. Pinto timing mark(s)

    Started by upnorthelan, 11.18.23 11:23 PM
    • Replies: 4
    • Views: 827
    11.19.23, 10:49 PM Go to last post

Page 1 of 126 1234511 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 38 users browsing this forum. (0 members & 38 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social