1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    254,909
Page 1 of 125 1234511 ... LastLast
Threads 1 to 40 of 4991

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 269,901
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 57,009
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 39,114
    01.15.14, 9:36 AM Go to last post
    • Replies: 0
    • Views: 144
    02.20.24, 3:38 PM Go to last post
  1. FC setup for VIR

    Started by Superjet800, 02.16.24 1:36 PM
    • Replies: 3
    • Views: 387
    02.20.24, 3:28 PM Go to last post
  2. Need an engine measurement

    Started by Rick Kirchner, 02.18.24 6:31 PM
    • Replies: 3
    • Views: 232
    02.19.24, 3:23 PM Go to last post
  3. How to check lube level in a Staffs box

    Started by Steve Demeter, 02.13.24 6:45 PM
    • Replies: 4
    • Views: 376
    02.14.24, 6:53 PM Go to last post
  4. AP 4 puck disc

    Started by Rick Kirchner, 02.08.24 1:13 PM
    • Replies: 7
    • Views: 514
    02.11.24, 4:04 PM Go to last post
  5. studs

    Started by Rick Kirchner, 02.08.24 1:36 PM
    • Replies: 11
    • Views: 643
    02.10.24, 3:08 PM Go to last post
    • Replies: 0
    • Views: 131
    02.09.24, 7:54 PM Go to last post
  6. Convert blade rear roll bar to T-post

    Started by Lyngengr, 01.30.24 12:31 PM
    • Replies: 12
    • Views: 994
    02.09.24, 4:30 PM Go to last post
  7. Five Spoke OZ wheels

    Started by John Green, 01.25.24 6:22 PM
    • Replies: 2
    • Views: 291
    02.09.24, 3:43 PM Go to last post
  8. VW type Cv joints

    Started by Steve Demeter, 01.25.24 7:11 PM
    • Replies: 6
    • Views: 952
    02.01.24, 9:56 AM Go to last post
  9. Bead seat sizing

    Started by redcar9, 01.22.24 12:08 AM
    • Replies: 17
    • Views: 1,319
    01.29.24, 2:39 PM Go to last post
  10. Pinto distributor wire

    Started by redcar9, 01.16.24 10:14 PM
    • Replies: 33
    • Views: 1,630
    01.29.24, 9:32 AM Go to last post
  11. Question about the Great Lakes CFC Group

    Started by Brian Graham, 01.21.24 10:23 AM
    • Replies: 2
    • Views: 275
    01.22.24, 11:02 AM Go to last post
    • Replies: 23
    • Views: 2,455
    01.21.24, 10:26 PM Go to last post
  12. Pinto piston rings

    Started by John Green, 01.04.24 11:46 AM
    • Replies: 2
    • Views: 398
    01.04.24, 6:47 PM Go to last post
  13. Snetterton Safety Device

    Started by JC86, 12.29.23 9:15 AM
    • Replies: 2
    • Views: 579
    12.29.23, 1:06 PM Go to last post
  14. Counter sink rivets

    Started by Hartley, 12.11.23 9:51 AM
    • Replies: 9
    • Views: 1,140
    12.24.23, 8:08 PM Go to last post
  15. Bsp- an- npt- male/female hell

    Started by John Green, 12.06.23 4:58 PM
    • Replies: 11
    • Views: 887
    12.07.23, 5:16 PM Go to last post
  16. Van Diemen clutch slave cylinder

    Started by Spengo, 03.03.23 8:07 PM
    • Replies: 38
    • Views: 5,001
    11.21.23, 7:29 PM Go to last post
  17. Pinto timing mark(s)

    Started by upnorthelan, 11.18.23 11:23 PM
    • Replies: 4
    • Views: 647
    11.19.23, 10:49 PM Go to last post
  18. Vinyl Wrap

    Started by John Green, 01.24.19 6:23 PM
    2 Pages
    1 2
    • Replies: 40
    • Views: 9,682
    11.12.23, 1:54 PM Go to last post
  19. American Racer tires

    Started by holmberg, 10.27.23 12:58 PM
    • Replies: 3
    • Views: 806
    10.29.23, 9:53 AM Go to last post
  20. Front wing (Bat) flaps

    Started by quickmag, 10.23.23 12:19 PM
    • Replies: 2
    • Views: 635
    10.23.23, 11:54 PM Go to last post
    • Replies: 6
    • Views: 907
    10.09.23, 8:30 AM Go to last post
  21. 96 vd test fit

    Started by djones, 10.04.23 6:09 PM
    • Replies: 7
    • Views: 963
    10.06.23, 5:36 PM Go to last post
  22. Zetec fuel pressure

    Started by quickmag, 09.28.23 7:50 PM
    • Replies: 4
    • Views: 710
    09.30.23, 1:16 PM Go to last post
  23. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,347
    09.10.23, 9:52 PM Go to last post
  24. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 489
    08.22.23, 7:36 PM Go to last post
  25. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 962
    08.05.23, 12:19 PM Go to last post
  26. 1985 Reynard spring rates

    Started by JWMotorsports, 07.30.23 8:56 PM
    • Replies: 4
    • Views: 743
    08.01.23, 4:44 AM Go to last post
  27. 2022-2023 entries

    Started by John LaRue, 07.11.23 2:32 PM
    • Replies: 34
    • Views: 3,154
    07.18.23, 5:20 PM Go to last post
  28. VD owner in Philadelphia/Allentown PA area

    Started by mwalsh, 07.04.23 10:22 PM
    • Replies: 2
    • Views: 806
    07.13.23, 11:25 AM Go to last post
  29. FC Questions

    Started by gmaloy, 07.05.23 11:13 AM
    • Replies: 14
    • Views: 1,946
    07.07.23, 10:34 PM Go to last post
  30. Fuel Cell

    Started by Rick Iverson, 07.01.23 6:09 PM
    • Replies: 18
    • Views: 1,812
    07.04.23, 7:47 AM Go to last post
  31. Ld200 parts

    Started by ewcmr2, 06.28.23 5:47 PM
    • Replies: 5
    • Views: 774
    06.30.23, 2:09 PM Go to last post
  32. Block crack on top bell housing tab

    Started by upnorthelan, 06.27.23 11:10 AM
    • Replies: 11
    • Views: 1,063
    06.29.23, 1:16 AM Go to last post
  33. Bearing Removal

    Started by Rick Iverson, 05.19.23 7:30 PM
    • Replies: 2
    • Views: 921
    06.28.23, 10:25 PM Go to last post
  34. Remove body side panels

    Started by mwalsh, 06.12.23 10:27 PM
    • Replies: 15
    • Views: 1,440
    06.16.23, 1:30 PM Go to last post
  35. Overheating question.

    Started by mwalsh, 06.13.23 10:14 PM
    • Replies: 1
    • Views: 514
    06.13.23, 11:32 PM Go to last post
  36. Noob question about oil changes

    Started by mwalsh, 06.08.23 10:47 PM
    • Replies: 5
    • Views: 886
    06.12.23, 10:28 PM Go to last post

Page 1 of 125 1234511 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 56 users browsing this forum. (1 members & 55 guests)

  1. redcar9

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social