1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    260,354
Page 1 of 125 1234511 ... LastLast
Threads 1 to 40 of 5000

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 286,311
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 57,964
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,027
    01.15.14, 9:36 AM Go to last post
  1. Vd starter issue, grinding flywheel

    Started by redcar9, 03.25.24 9:11 PM
    2 Pages
    1 2
    • Replies: 41
    • Views: 1,651
    04.08.24, 8:57 PM Go to last post
  2. Pinto fuel pump

    Started by John Green, 04.03.24 4:20 PM
    • Replies: 19
    • Views: 598
    04.05.24, 3:31 PM Go to last post
  3. 2.0l pinto timing light

    Started by redcar9, 04.02.24 5:48 PM
    • Replies: 8
    • Views: 323
    04.03.24, 11:17 AM Go to last post
  4. ISO Van Diemen RF97 manual

    Started by Thrlskr, 04.04.23 9:16 PM
    • Replies: 4
    • Views: 842
    04.02.24, 10:28 PM Go to last post
  5. Pinto distributor wire

    Started by redcar9, 01.16.24 10:14 PM
    • Replies: 34
    • Views: 2,159
    04.02.24, 5:36 PM Go to last post
  6. Pinto 2.0 points and condenser source

    Started by John Green, 03.31.24 5:40 PM
    • Replies: 3
    • Views: 268
    04.01.24, 1:23 PM Go to last post
  7. Hewland 9 ratio change???

    Started by rorym, 05.06.10 5:29 AM
    • Replies: 28
    • Views: 8,703
    03.27.24, 4:17 PM Go to last post
  8. AP 4 puck disc

    Started by Rick Kirchner, 02.08.24 1:13 PM
    • Replies: 10
    • Views: 1,121
    03.26.24, 4:57 PM Go to last post
  9. Moved: Right Formula Racing is open for business!

    Started by oppermann, 03.26.24 2:48 PM
    •  
    •  
  10. 93 VD Upright dissassembly

    Started by Rspink2012, 03.26.24 8:58 AM
    • Replies: 0
    • Views: 127
    03.26.24, 8:58 AM Go to last post
  11. High oil pressure

    Started by John Green, 03.24.24 7:10 PM
    • Replies: 7
    • Views: 578
    03.25.24, 2:11 PM Go to last post
  12. Moved: Hoosier Bias Rain Tires 21.0x6.5-13W3

    Started by tmet07, 03.15.24 10:18 AM
    •  
    •  
  13. zetec crank picup

    Started by jimj11, 03.08.24 12:23 PM
    • Replies: 1
    • Views: 456
    03.11.24, 11:54 AM Go to last post
  14. Bead seat sizing

    Started by redcar9, 01.22.24 12:08 AM
    • Replies: 19
    • Views: 1,928
    03.04.24, 1:16 PM Go to last post
    • Replies: 0
    • Views: 300
    02.20.24, 3:38 PM Go to last post
  15. FC setup for VIR

    Started by Superjet800, 02.16.24 1:36 PM
    • Replies: 3
    • Views: 536
    02.20.24, 3:28 PM Go to last post
  16. Need an engine measurement

    Started by Rick Kirchner, 02.18.24 6:31 PM
    • Replies: 3
    • Views: 343
    02.19.24, 3:23 PM Go to last post
  17. How to check lube level in a Staffs box

    Started by Steve Demeter, 02.13.24 6:45 PM
    • Replies: 4
    • Views: 488
    02.14.24, 6:53 PM Go to last post
  18. studs

    Started by Rick Kirchner, 02.08.24 1:36 PM
    • Replies: 11
    • Views: 827
    02.10.24, 3:08 PM Go to last post
    • Replies: 0
    • Views: 195
    02.09.24, 7:54 PM Go to last post
  19. Convert blade rear roll bar to T-post

    Started by Lyngengr, 01.30.24 12:31 PM
    • Replies: 12
    • Views: 1,301
    02.09.24, 4:30 PM Go to last post
  20. Five Spoke OZ wheels

    Started by John Green, 01.25.24 6:22 PM
    • Replies: 2
    • Views: 374
    02.09.24, 3:43 PM Go to last post
  21. VW type Cv joints

    Started by Steve Demeter, 01.25.24 7:11 PM
    • Replies: 6
    • Views: 1,169
    02.01.24, 9:56 AM Go to last post
  22. Question about the Great Lakes CFC Group

    Started by Brian Graham, 01.21.24 10:23 AM
    • Replies: 2
    • Views: 352
    01.22.24, 11:02 AM Go to last post
    • Replies: 23
    • Views: 2,651
    01.21.24, 10:26 PM Go to last post
  23. Pinto piston rings

    Started by John Green, 01.04.24 11:46 AM
    • Replies: 2
    • Views: 493
    01.04.24, 6:47 PM Go to last post
  24. Snetterton Safety Device

    Started by JC86, 12.29.23 9:15 AM
    • Replies: 2
    • Views: 677
    12.29.23, 1:06 PM Go to last post
  25. Counter sink rivets

    Started by Hartley, 12.11.23 9:51 AM
    • Replies: 9
    • Views: 1,239
    12.24.23, 8:08 PM Go to last post
  26. Bsp- an- npt- male/female hell

    Started by John Green, 12.06.23 4:58 PM
    • Replies: 11
    • Views: 981
    12.07.23, 5:16 PM Go to last post
  27. Van Diemen clutch slave cylinder

    Started by Spengo, 03.03.23 8:07 PM
    • Replies: 38
    • Views: 5,278
    11.21.23, 7:29 PM Go to last post
  28. Pinto timing mark(s)

    Started by upnorthelan, 11.18.23 11:23 PM
    • Replies: 4
    • Views: 719
    11.19.23, 10:49 PM Go to last post
  29. Vinyl Wrap

    Started by John Green, 01.24.19 6:23 PM
    2 Pages
    1 2
    • Replies: 40
    • Views: 10,197
    11.12.23, 1:54 PM Go to last post
  30. American Racer tires

    Started by holmberg, 10.27.23 12:58 PM
    • Replies: 3
    • Views: 905
    10.29.23, 9:53 AM Go to last post
  31. Front wing (Bat) flaps

    Started by quickmag, 10.23.23 12:19 PM
    • Replies: 2
    • Views: 701
    10.23.23, 11:54 PM Go to last post
    • Replies: 6
    • Views: 1,042
    10.09.23, 8:30 AM Go to last post
  32. 96 vd test fit

    Started by djones, 10.04.23 6:09 PM
    • Replies: 7
    • Views: 1,091
    10.06.23, 5:36 PM Go to last post
  33. Zetec fuel pressure

    Started by quickmag, 09.28.23 7:50 PM
    • Replies: 4
    • Views: 817
    09.30.23, 1:16 PM Go to last post
  34. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,458
    09.10.23, 9:52 PM Go to last post
  35. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 543
    08.22.23, 7:36 PM Go to last post
  36. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 1,031
    08.05.23, 12:19 PM Go to last post

Page 1 of 125 1234511 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 54 users browsing this forum. (0 members & 54 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social