1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    247,098
Page 1 of 125 1234511 ... LastLast
Threads 1 to 40 of 4974

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 261,205
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 55,006
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 36,882
    01.15.14, 9:36 AM Go to last post
  1. Van Diemen clutch slave cylinder

    Started by Spengo, 03.03.23 8:07 PM
    • Replies: 38
    • Views: 4,125
    11.21.23, 7:29 PM Go to last post
  2. Pinto timing mark(s)

    Started by upnorthelan, 11.18.23 11:23 PM
    • Replies: 4
    • Views: 345
    11.19.23, 10:49 PM Go to last post
  3. Vinyl Wrap

    Started by John Green, 01.24.19 6:23 PM
    2 Pages
    1 2
    • Replies: 40
    • Views: 8,610
    11.12.23, 1:54 PM Go to last post
  4. American Racer tires

    Started by holmberg, 10.27.23 12:58 PM
    • Replies: 3
    • Views: 606
    10.29.23, 9:53 AM Go to last post
  5. Front wing (Bat) flaps

    Started by quickmag, 10.23.23 12:19 PM
    • Replies: 2
    • Views: 469
    10.23.23, 11:54 PM Go to last post
    • Replies: 6
    • Views: 680
    10.09.23, 8:30 AM Go to last post
  6. 96 vd test fit

    Started by djones, 10.04.23 6:09 PM
    • Replies: 7
    • Views: 694
    10.06.23, 5:36 PM Go to last post
  7. Zetec fuel pressure

    Started by quickmag, 09.28.23 7:50 PM
    • Replies: 4
    • Views: 525
    09.30.23, 1:16 PM Go to last post
    • Replies: 20
    • Views: 1,721
    09.26.23, 5:53 PM Go to last post
  8. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,055
    09.10.23, 9:52 PM Go to last post
  9. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 392
    08.22.23, 7:36 PM Go to last post
  10. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 776
    08.05.23, 12:19 PM Go to last post
  11. 1985 Reynard spring rates

    Started by JWMotorsports, 07.30.23 8:56 PM
    • Replies: 4
    • Views: 567
    08.01.23, 4:44 AM Go to last post
  12. 2022-2023 entries

    Started by John LaRue, 07.11.23 2:32 PM
    • Replies: 34
    • Views: 2,410
    07.18.23, 5:20 PM Go to last post
  13. VD owner in Philadelphia/Allentown PA area

    Started by mwalsh, 07.04.23 10:22 PM
    • Replies: 2
    • Views: 575
    07.13.23, 11:25 AM Go to last post
  14. FC Questions

    Started by gmaloy, 07.05.23 11:13 AM
    • Replies: 14
    • Views: 1,563
    07.07.23, 10:34 PM Go to last post
  15. Fuel Cell

    Started by Rick Iverson, 07.01.23 6:09 PM
    • Replies: 18
    • Views: 1,372
    07.04.23, 7:47 AM Go to last post
  16. Ld200 parts

    Started by ewcmr2, 06.28.23 5:47 PM
    • Replies: 5
    • Views: 555
    06.30.23, 2:09 PM Go to last post
  17. Block crack on top bell housing tab

    Started by upnorthelan, 06.27.23 11:10 AM
    • Replies: 11
    • Views: 822
    06.29.23, 1:16 AM Go to last post
  18. Bearing Removal

    Started by Rick Iverson, 05.19.23 7:30 PM
    • Replies: 2
    • Views: 726
    06.28.23, 10:25 PM Go to last post
  19. Remove body side panels

    Started by mwalsh, 06.12.23 10:27 PM
    • Replies: 15
    • Views: 1,135
    06.16.23, 1:30 PM Go to last post
  20. Overheating question.

    Started by mwalsh, 06.13.23 10:14 PM
    • Replies: 1
    • Views: 378
    06.13.23, 11:32 PM Go to last post
  21. Noob question about oil changes

    Started by mwalsh, 06.08.23 10:47 PM
    • Replies: 5
    • Views: 720
    06.12.23, 10:28 PM Go to last post
  22. Zetec Fuel Pressure Regulator O-ring

    Started by Jon Jeffords, 05.28.23 9:38 AM
    • Replies: 4
    • Views: 579
    05.31.23, 8:03 PM Go to last post
  23. ECU location in an RF01?

    Started by BeerBudgetRacing, 05.07.23 5:03 PM
    • Replies: 8
    • Views: 984
    05.18.23, 12:30 PM Go to last post
  24. Fuel settings for FRP MZR fuel map

    Started by Redawgleader, 05.15.23 6:17 PM
    • Replies: 0
    • Views: 387
    05.15.23, 6:17 PM Go to last post
  25. Ride Height Measurement Points

    Started by Rick Iverson, 05.06.23 8:08 PM
    • Replies: 5
    • Views: 790
    05.07.23, 2:55 PM Go to last post
  26. AP LD20 calipers vs Wilwood

    Started by Monte, 05.02.23 11:53 AM
    • Replies: 19
    • Views: 1,564
    05.06.23, 4:12 PM Go to last post
  27. Zetec Flywheel Protection?

    Started by Lyngengr, 04.17.23 12:26 PM
    • Replies: 14
    • Views: 1,261
    05.02.23, 11:29 AM Go to last post
  28. Bolt Map

    Started by Rick Iverson, 04.26.23 11:07 AM
    • Replies: 0
    • Views: 511
    04.26.23, 11:07 AM Go to last post
    • Replies: 6
    • Views: 820
    04.22.23, 1:39 PM Go to last post
  29. TPS Sensor for Zetec

    Started by gavinaitken, 11.16.16 1:09 PM
    • Replies: 11
    • Views: 2,656
    04.20.23, 9:09 PM Go to last post
  30. Micron 5 RPM accuracy

    Started by J Weida, 04.16.23 5:04 PM
    • Replies: 4
    • Views: 573
    04.16.23, 11:34 PM Go to last post
  31. Zetec Crank Sensor

    Started by quickmag, 04.14.23 12:55 PM
    • Replies: 5
    • Views: 592
    04.14.23, 5:42 PM Go to last post
  32. 3D printable FC Models

    Started by RSS, 02.17.22 7:15 PM
    • Replies: 19
    • Views: 3,147
    04.10.23, 2:19 PM Go to last post
  33. ISO Van Diemen RF97 manual

    Started by Thrlskr, 04.04.23 9:16 PM
    • Replies: 0
    • Views: 366
    04.04.23, 9:16 PM Go to last post
  34. Rubber versus Steel Brake Lines

    Started by racpercival, 03.12.23 1:31 AM
    • Replies: 5
    • Views: 965
    03.30.23, 6:28 PM Go to last post
  35. Carb question?

    Started by pcarnut, 03.28.23 3:28 PM
    • Replies: 2
    • Views: 669
    03.30.23, 4:09 PM Go to last post
  36. Looking for Van Diemen wheel

    Started by FormulaC44, 03.21.23 11:55 AM
    • Replies: 3
    • Views: 612
    03.28.23, 3:11 PM Go to last post
  37. FC/F2000 Ad Hoc Committee

    Started by John LaRue, 02.11.20 4:53 PM
    • Replies: 33
    • Views: 7,147
    03.28.23, 9:57 AM Go to last post

Page 1 of 125 1234511 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 95 users browsing this forum. (0 members & 95 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social