Sold. Thanks to all who looked!
Sold. Thanks to all who looked!
Last edited by Rene Gimenez; 12.21.23 at 9:43 PM. Reason: Sold the item
Hi, Rene. By the spin marks, it looks like the friction plates have been previously installed. That's ok, so long as they aren't too worn. I am interested in buying them. Can you please send me a photo of a micrometer reading showing the thickness of the friction surface of each plate?
- Darcy 403.585.2631
Hi Darcy-
This clutch disc was installed on the engine when it was purchased, so that may account for the marks. Per the attached photo, this disc is reading 2.71mm / 0.10669in. I hope this addresses you question. Thank you for the inquiry!
One plate available. Correct?
I'm sorry for any confusion- this is for one disc. Again, this was on the FF1600 engine that I purchased last year and I needed the 7/8 input spline. As an aside- a little over 15 years ago I ran a FF2000/Van Diemen/Pinto and ran a Tilton 7.25 single disc clutch as well. Again, my sincere apologies.
I'll take it. I can pick it up at the track or sometime convenient.
Unless you need it sooner, I'll haul it with me to the first VARA race at Willow.
-Rene
There are currently 1 users browsing this thread. (0 members and 1 guests)