2 part foam seat...

[oh2winindy]

Bill @ 10/tenths helped us pour a 2 part foam seat the other day. It came out awesome, but I need to pour just a tiny bit more into the back part. I forget the mix ratio of the two parts.

Anyone remember off the top of there head?

Thanks in advance!!

[Jim Garry]

It's 1:1.

Jim

[oh2winindy]

Thanks Jim!!!

[EYERACE]

after one was poured, thanks again Alan, and it was trimmed and trimmed and cut and trimmed some more - used a hack saw blade in a one hand holder and also a black and decker rechargable battery power reciprocating saw and also a Stanley sureform - i've seen the seat covered in suede or all duct tape but i took it to a local upholstery shop and they rolled and pleated and then glued on a leather cover for about $30.00, the seat is small so there's really not that much in materials cost when they have a large scrap as a left over piece and it only took about an hour of labor - it's always a crowd pleaser and has held up well - it was made in a color that matches the belts