Axle Shafts Van Diemen

[jwilless]

SOLD SOLD


4 Brand new custom Axles for Van Diemen or other tripod assembly. These are 20" total length with some nice little improvements from Velocity Haus.

300M Gun Drilled with aluminum end caps.
30 Spline and around .875 OD along the smooth portion.

I ordered these for a custom setup and need something a bit longer after a redesign. These should work fine with a standard VD using 19.75" shafts.

$900 shipping included. These now cost over $500 / axle!
$900 for $2000 worth of top notch hardware.

emailing directly is best.

Justin Willess
540-230-9047
jwilless@itd-nc.com

[t walgamuth]

4 Brand new custom Axles for Van Diemen or other tripod assembly. These are 20" total length with some nice little improvements from Velocity Haus.

300M Gun Drilled with aluminum end caps.
30 Spline and around .875 OD along the smooth portion.

I ordered these for a custom setup and need something a bit longer after a redesign. These should work fine with a standard VD using 19.75" shafts.

$900 shipping included.

emailing directly is best.

Justin Willess
540-230-9047
jwilless@itd-nc.com

Will they fit my 98 VD? I would only need two right?

[greg pizzo]

Just a note on these and every axle we offer now
They are all made exclusively by Mark Williams in CO
These are spare no expense top shelf axles!
You will not find any axles made that are done at this level of excellence !

[jwilless]

I have two used solid axles that I can throw for free if interested

[jwilless]

These will work just fine as a replacement for the 19.75" axles on VD.
$500 for the set including shipping to the lower 48.
Justin

[jwilless]

Any VD owners need a set of high quality axles?

[jwilless]

$450 shipped for a pair (2 axles).

Any VD owners need a set of high quality axles?