Rod Ends / Spherical Bearings

[goncalv3]

Is everyone using rod ends directly out of SCCA Enterprises? Just curious if anyone else out there had used Aurora or any other supplier? How often are you replacing? I have a couple that need replaced and trying to figure out whats going to give me the best reliability.

Thanks!

[Skelly]

Go with Aurora. When I had my enterprise car that is what I changed to when I found any of them worn out.

Sean
FC, FF, FM, scca enterprise

[Numbskull XIV]

Is everyone using rod ends directly out of SCCA Enterprises? Just curious if anyone else out there had used Aurora or any other supplier? How often are you replacing? I have a couple that need replaced and trying to figure out whats going to give me the best reliability.

Thanks!

Aurora is the way to go.
Hope this helps,

Jon Updegrove
USF2000 + Pro Mazda Mechanic

[goncalv3]

Aurora is the way to go.
Hope this helps,

Jon Updegrove
USF2000 + Pro Mazda Mechanic

Thank you. Are you guys using the RXAM/B serires (Pegasus 3063?)

Rod end supply has the similar size and strength rating at a much lower cost. i don't know how their durability is. not a place i wanted to cut corners. I heard they had an impressive stand at PRI so I was curious if anyone had tried it. I was thinking of trying them. the fact that they were much cheaper is actually scaring me from pulling the trigger.

[jcorsico]

Is everyone using rod ends directly out of SCCA Enterprises? Just curious if anyone else out there had used Aurora or any other supplier? How often are you replacing? I have a couple that need replaced and trying to figure out whats going to give me the best reliability.

I have had very good luck with the Aurora 3063 (Pegasus number) or the AB-PRXMT (Pegasus number) on my FE. They are very nicely made units, particularly the AB-PRXMT models.

I only replace them when they are noticeably worn or damaged.