This is the engine built by Jennings for Charlie Kulmann to run at the Runoffs in Topeka '06. 85mm bore and 70mm stroke. Not run since 2006 to the best of my knowledge. $20,000.
This is the engine built by Jennings for Charlie Kulmann to run at the Runoffs in Topeka '06. 85mm bore and 70mm stroke. Not run since 2006 to the best of my knowledge. $20,000.
How about a picture to see it.
$ 20 K seems a lot just for the block ?
Is it just block or is it a short block ?
Crank ? Rods ? Pistons ? or ?
What does that work out to displacement wise ?
What does it weigh ?
How much lighter it it than a cast iron block ?
M.
It is a complete engine, carbs to flywheel. I have not weighed the engine but i figure about 25 to 30 pounds lighter than the iron block version. The engine was built of CSR so it is just under 1600cc.
There are currently 1 users browsing this thread. (0 members and 1 guests)