Beach MK4 Sports Racer Hub Parts Needed

[true racer]

We have a Beach MK4 Sports racer that is in need of a stub axle (or pair of) with mating U-joint yoke or CV flanges. We have the stub axle and CV flange for one side, but need another set to match for the other side. But we would prefer a complete set of stub axle and U-joint yokes for both sides. Dimensions are as follows:

Wheel bearing surface OD -- 1.375"
Spline -- 1.288 x 6 spline
Approximate overall length -- 4 5/8"
Bolt pattern -- 4 on 3 3/4"

Photos are of the parts that we have now. If you have something close, we can do whatever is required to make it work. Please let me know what you have and how much it will take for me to own it.

Robert Metcalf
Metcalf Racing
972-494-3434 office
214-298-9837 cell
metcalfracing.com

[Robert J. Alder]

John Rankin (SOVREN or HMSA?) might know something about this. He runs a very neat Beach.
http://alder.smugmug.com/Hobbies/Ren...Race/i-Ks9sZnj

[true racer]

Have already spoken to John about it. Are you listening John? Did you find anything?

Thank you, Bob. Hope everything is good with you.

Robert

[Steve Demeter]

If you can't find something, Doug at Fast Forward can make pretty much anything, particularly if he has a sample.

It usually is out of 430M(IIR alloy # correctly) some pretty tough stuff. And his work is impeccable.

[Robert J. Alder]

Ditto Mark Williams Enterprises here in the Denver area. They've done some custom stub axle work for me. Not cheap, but great bits.
http://www.markwilliams.com/