Pi 3+ /Pro Dash/ V6 Question
Any experts out there? Apparently I’m not one! I have a Swift 014 with the PECTEL T6, using Pi Professional Dash with the Pi Combo expansion display and Pi3+ acquisition'
I am trying to display the Gearpot position on the Expansion Single LED display. In PI V6 the Gearpot Channel shows only as a system channel (i.e. via the ECM link, I think) and not a Physical Channel.
Bottom line is I cannot display the gear position, 0-5, although I can display the raw data on the other part of the display. I could probably tap into pot its self and split the signal and create a physical channel. All the thresholds are set correctly in theT6.
I know most people gave up on this Pi stuff a long time ago and probably folks will tell me to move into the modern world, but I’m sure there is someone one out there willing to join my quest! Any input or direction is appreciated
Reply With Quote
