Car: F1000 Speads RM04
Engine: Suzuki 1000 K4 2004 with wet sump.
Today I setup MyChron3 XG Log. Everything is fine except 2 things:
1. Oil Pressure. I set the oil pressure to PSI .1 and it gives me pretty high read out of a range 80 - 120. Is this normal? What should I set the limits to?
When I switched to BAR as oppose to PSI I did receive this range: 4-12. ?
Numbers seem high to me.
2. Gear calculation. I don't have a manual, so I'm not sure how to program the gear selection. When I jack the rear of the car up and run it in a gear MyChron3 does not display a anything in the gear selection. I don't even see 0 in there. When I start the car and MyChron3 initializes it blinks 0 for a moment, so I know the light itself works.
On the dash there is a Menu button. I pressed that thing and it said: Calculating Gear, but nothing really happened. I can figure this one out, but the oil thing is puzzling.