Could someone confirm the water flow in a GSXR 600. I believe it to exit the head under the intake, go to thru the cooling system, back through the water pump, and enter the block under the exhaust headers. Is this correct?
Could someone confirm the water flow in a GSXR 600. I believe it to exit the head under the intake, go to thru the cooling system, back through the water pump, and enter the block under the exhaust headers. Is this correct?
That's how it goes on a GSXR1000
Remember,.......always out from the thermostat housing.
Stonebridge Sports & Classics ltd
15 Great Pasture Rd Danbury, CT. 06810 (203) 744-1120
www.cryosciencetechnologies.com
Cryogenic Processing · REM-ISF Processing · Race Prep & Driver Development
Bottom of the radiator goes to the water pump inlet. The outlet where the thermostat is goes to the water swirl tank and then the outlet hose from the swirl tank goes to the top of the radiator. All other factory hoses on the engine remain the same except for the factory oil cooler hoses and the oil cooler itself, which is replaced with a blanking plate and all hoses for the factory cooler are removed and the hose fittings are plugged.
Also make sure that the swirl tank is higher than the head and that the vent from the thermostat housing goes near the top of the swirl tank.
Sounds complicated but it is essentially the same for every engine installation.
Thanks ... Jay Novak
313-445-4047
On my 54th year as an SCCA member
with a special thanks to every SCCA worker (NONE OF US WOULD RACE WITHOUT THE WORKERS)
There are currently 1 users browsing this thread. (0 members and 1 guests)