Spherical bearing staking tool to borrow or buy

[JHerscher]

I’d like to borrow or buy (if it’s not a crazy figure!) a staking tool for the spherical bearing used in late model Van Diemen rear upper wishbones. Bearing number is PWB-6TG. 3/8” bore x 13/16 OD. Center of v groove is right at 0.700”

Obviously I’ll pay freight both ways for a borrowed tool and turn it back around as soon as I am done with it.

PM me if you have anything.

thanks
John

[Steve Demeter]

this shows the design and if you have access to a lathe it should be pretty easy to make.

https://www.nhbb.com/knowledge-cente...ing-procedures

I have used a socket in a pinch in the past

[Skip Weld]

Hi John, I think I may have that size. I will check this morning.
Skip Weld

[Skip Weld]

Hi John, I think I may have that size. I will check this morning.
Skip Weld

[Skip Weld]

It is odd that it sent my reply twice.
John< I have a pair of .700.
Call me or text me.
Skip Weld
Weldmotorsports@gmail.com

[JHerscher]

Thanks Skip. I'll turn it back around quickly.

Forum, I have the tooling for the smaller size bearing (Aurora AWC-5TG) that I'll be happy to loan to anyone under the same terms as I noted above.

John