I have a Flatshifter Expert/Max system on my Stohr WF1 that I've managed to mess up somehow. After reassembling the car this spring it had no spark. Tracing the issue, I found the ignition cut circuit of the Expert system (for upshifts) was adding a lot of resistance to the system. Assuming I had accidently switched polarity of the connection to my K6 ignition system I reversed the connection and had a running motor.
Except.. now if there is any ignition cut I cannot detect it. Have to crack throttle on every upshift to successfully get the next gear.
Digging back into the manual it looks like this current setup is reversed from what it should be, with a warning of dire consequences if done incorrectly. Much as I would like to follow the manual, having a running motor is kinda nice.
So, am I sending this unit to England.. or can someone here point out where/how I've been an idiot? (probably both)
Phil Leavens
2004 Stohr WF1 "Rocket"