1. what torque setting do you guys use on the PFM wheel nuts?
2. what tire pressure do you usually start off with (cold) and what is your target for (warm)?
1. what torque setting do you guys use on the PFM wheel nuts?
2. what tire pressure do you usually start off with (cold) and what is your target for (warm)?
I had this same question and someone answered it for me.
Wheel nut torque: 104-108 lbs
Stsrting tire pressure: 16 psi, check again after first run, it should be 20 psi.
I think 104 is too low.
The Torque spec sheet on this page (BTW everthing you need to know about running one of those cars seems to be there):
http://starracecars.com/resources.html
indicates 130 lbs-ft for the Wheel Nut similar to most of the other Van Diemen cars (we use 135 for the S2 and FC cars).
There are currently 1 users browsing this thread. (0 members and 1 guests)