CNC Water Jet Aluminum or LASER Cut Carbon Fiber

[Rick Iverson]

Gents;

Switching over to Stack ST8100, and need a mounting plate. Any recommendations as to a provider? I surmise the most economical will be aluminum. Thoughts?

[R. Pare]

The should be plenty of water jetter down near you somewhere, but if you cannot fond one, I use Waterjet Cutting of Indiana here on the west side near IRP.

http://www.waterjetcuttingofindiana.com/

[SteveG]

These folks specialize in small run prototypes and can do full production quantities.
Check out their material list!
We use them all the time.

https://sendcutsend.com/