Gents;
Switching over to Stack ST8100, and need a mounting plate. Any recommendations as to a provider? I surmise the most economical will be aluminum. Thoughts?
Gents;
Switching over to Stack ST8100, and need a mounting plate. Any recommendations as to a provider? I surmise the most economical will be aluminum. Thoughts?
V/r
Iverson
The should be plenty of water jetter down near you somewhere, but if you cannot fond one, I use Waterjet Cutting of Indiana here on the west side near IRP.
http://www.waterjetcuttingofindiana.com/
These folks specialize in small run prototypes and can do full production quantities.
Check out their material list!
We use them all the time.
https://sendcutsend.com/
There are currently 1 users browsing this thread. (0 members and 1 guests)