Okay, this is the lower rear suspension front pickup point on my Swift DB-1. When I pull in the direction of the arrows, there is visible movement of the rod-end, but no visible movement of the bolt. I have replaced the bolt and rod-end, but no change. Therefore, despite the lack of movement of the bolt, I think I have to consider that the hole is wallowed out [love to use the technical terminology] I think the next step is to hone the hole true-round again, and sleeve it. However, there isn't a lot of meat there, so the sleeve has to be very thin. Does anyone have any better idea? Is there a sleeve kit for this problem? Anyone know of someone who can make an accurate sleeve for this application?
Thanks for your thoughts