Folks,
Need about 100 1/2" diameter hole blanks to weld into a pile of holes in a tin top race car. 18 gauge would be fine, or thicker. Can't find a source online.
Thanks, and Merry Christmas
BT
Folks,
Need about 100 1/2" diameter hole blanks to weld into a pile of holes in a tin top race car. 18 gauge would be fine, or thicker. Can't find a source online.
Thanks, and Merry Christmas
BT
https://www.ebay.com/itm/1-2-Inch-St...MAAOSwhctdX0ic
Or just go to any sheet metal fab shop and have them punch out some for you.
There are currently 1 users browsing this thread. (0 members and 1 guests)