Source for sheetmetal, weldable 1/2" hole blanks

[billtebbutt]

Folks,

Need about 100 1/2" diameter hole blanks to weld into a pile of holes in a tin top race car. 18 gauge would be fine, or thicker. Can't find a source online.

Thanks, and Merry Christmas

BT

[R. Pare]

https://www.ebay.com/itm/1-2-Inch-St...MAAOSwhctdX0ic

Or just go to any sheet metal fab shop and have them punch out some for you.

[billtebbutt]

https://www.ebay.com/itm/1-2-Inch-St...MAAOSwhctdX0ic

Or just go to any sheet metal fab shop and have them punch out some for you.

Thanks! I know t sounds stupid, but I goog'ed this and could not find a source using my nomenclature. Sometimes you just need the correct words!

cheers!
BT