Lynx B Unconversion

[veeracer98]

We have a Lynx B with the zero roll conversion. Going to convert it back to a Z bar. Unfortunately the top part of the frame has been cut off. If someone has a lynx B, can they measure the height of the back frame for me and the size of the cross bar?

Thanks

Dave

[pacratt]

PM sent.

[TJSFVGUY]

We have a Lynx B with the zero roll conversion. Going to convert it back to a Z bar. Unfortunately the top part of the frame has been cut off. If someone has a lynx B, can they measure the height of the back frame for me and the size of the cross bar?

Thanks

Dave

Dave,

I have a fixture for locating the angle iron engine mounts, should you need it.

[veeracer98]

Dave,

I have a fixture for locating the angle iron engine mounts, should you need it.

Thanks Tom