FS: Pinto engine and clutch parts, LD20s, wheels

[2BWise]

I've got too much hardware. Way more spares than necessary, so I'd like to make some room in the garage. Prices listed but offers considered. Shipping not included, but assume USPS flat rate ($6-$18 for small or large) on everything except the wheels.

2 - 5" Tilton clutch covers - $150 each
1 - 5" Tilton clutch disk, new - $80
1 - Bosch distributor with electronic ignition installed - $250
1 - Weber carb - $200
1 - Tilton 7.25" clutch assembly, used disc - $300
1 - TDC oil pump - Sold
2 - AP/Lockheed LD20 calipers, $100 each
1 - Protofab late-VD universal upright, wheel bearing and cap included - $250
1 set - 4 2L pistons and rods, Crower rods, Ford Racing pistons (some pitting, worst one is pictured, priced for just the rods as they're good) - Sold
1 - Technomag 6" wheel, late-VD front offset and pin sizing - $150
1 - 12 spoke OZ 6" wheel, late-VD front offset and pin sizing (shows damage on inner edge from a loose LBJ, purely cosmetic) - $150

PM or email me for parts interested in.

[patman]

Would you sell me just the pistons? I have good rods for my spare engine but need some pistons.

[2BWise]

Would you sell me just the pistons? I have good rods for my spare engine but need some pistons.

PM sent

[2BWise]

Updated. P&Rs gone as well as the oil pump. Open to offers on the rest.