Spec Racer Ford possibly coming to rFactor2

[Keith Carter]

See the WIP thread here:

http://isiforums.net/f/showthread.ph...pec-Racer-Ford

[AjC Jr]

cool, if they need anything let me know, may be i can help them or put them in touch with people who can

[Keith Carter]

He will most likely need some dimensional data among other things. Do you have rFactor2? We're also looking for someone who has had a lot of seat time in a Gen2 and Gen3 SRF with rFactor2 to be a test dummy.

[FrankRizzo]

He will most likely need some dimensional data among other things. Do you have rFactor2? We're also looking for someone who has had a lot of seat time in a Gen2 and Gen3 SRF with rFactor2 to be a test dummy.

I can help with that! In the place where you set front grip, it's a scale of 1-100, set it to -5. ;-)

[AjC Jr]

did this ever happen?

[Keith Carter]

Still a wip. I'll send you a pm.

[Keith Carter]

For anyone willing to help, we're looking to get the following information for the SRF (gen2 or gen3):

• Suspension geometry;
• Spring, shock and bump stop rates (and travel);
• Weights and dimensions for the car, rims (2 of the most common composites should suffice, I'd say aluminium and steel) and wheel hubs;
• Aerodynamic values (downforce and drag) separated by main body, front and rear elements and overall, if possible, at varying speeds (3 should be enough, more would be good);
• All tire data you can get me (dimensions, construction, slip curves, etc).
• Engine HP and torque curves / dyno sheet

[AjC Jr]

http://scca-e.com/race-cars/spec-racer-ford/

some of the specs are for Gen2, i would give Enterprises a call for Gen3 motor specs

[AjC Jr]

again may be for gen 2

http://www.mummbrothers.com/SRF_Stuf...ske_Shocks.htm

try Shawn at motion dynamics, tell him i sent ya, he has my car up there in NH.

[Davidcaruso77]

This thread is a little old, but any hope of the SRF coming to rFactor 2?