WTH is it ??

[Pop Chevy]

This piece came with an Indy Lights car I bought yrs ago and I never figured out what the heck it was for. Any Ideas ?

[Daryl DeArman]

WAG---Some kind of fixture to keep the steering centered while doing alignment?

[gmac]

It is a size 2 Transcondibulator

[uniform]

Disgronificator.

[Swift17]

...that it is muffler bearing alignment tool with the unobtainable attachment to check total runout by spinning the muffler against the two small wheels

[provamo]

did that lites car have push rod suspension?

[Pop Chevy]

Hah, you got me ! No it had pull rod sus. 89 March

[racerdad2]

Highly engineered , lightened , non-ferros , whizzy bit & don't forget , Spendy !!!

[lucky13]

If you wrapped a chain around the two little wheels it might be a decent boat anchor.

[Steve Demeter]

Looks like a dummy frammus rod to wheel the car aropund without the engine

[rickb99]

It's two bologna slicers without the main cutting wheels. Jus the 2 smaller guide wheels.

[Terry Hanushek]

Pops

Aren't you glad that you asked?

T

[Albatross]

It's the missing part of a $15,000 DB-1 that will make it an $18,000 DB-1 when purchased.

[racerdad2]

All kidding aside... It's The ziffle plug alignment & retainer tool that allows the proper insertion of the krinkle pin thru the spark plug gears, thereby giving proper tension to the muffler belt, thereby keeping one under the noise levels mandated at some tracks....

[Pop Chevy]

Yes , I'm glad I asked ! Been tripping over it for years and couldn't figure it out. Now I don't feel so bad and the responses so far are good for a laugh. Thanks guys ! and Happy Easter !

[Neil_Roberts]

I guess that there could be a remote chance that it might possibly be a very home-made ring & pinion setup jig, or perhaps a diff setup fixture. But it's probably a kaloozoid johackle.

[DanW]

I'm pretty sure its a fixture that goes on your head where the two round things clamp over your ears.

Then Steve Lathrop builds a tin foil hat over it so the martians cannot upload your brain.

[tim gaffney]

It is a turboentabulator it is made of prefamulated amulate

[fatdaddy53]

After a lengthy study of the pictures, I am sure that it is a wavelength calibrator for the flux capacitor. Note the green and red strips to keep from getting the wrong side of the wave.