SOLD --- SOLD --- SOLD
Looking to sell my 1984 Dare Devil F500. This car was driven to the F-Mod National championship in 2009. This car was developed by Jim Murphy and is now available. I am going to B-Mod and would like to sell the car before the 2012 season starts.
This car is a blast to drive and is capable of trophying at Nationals in 2012. You won't go faster for less.
Car is located in Walworth, New York.
I'm asking $5,500 for the car and extensive spares package. This is a great deal for someone looking to get started in F-Mod. The car is set up for a tall driver (I'm 6'4")
1984 Red Devil w/KBS Mk.7 rear clip
Rotax 493 – good compression, MPEM, electric starter and Weinandt pipe
Muffler with mount – good for 92+dB
Rocker arm front & rear suspension – optimized
Inline electric water pump w/switch – cools motor down between runs
Two new custom aluminum radiators w/fans on same switch as above
Copper tubing used in parallel cooling system
Electric water temperature gauge
Smallest steering wheel on steel/steel take off hub
Quickest steering ratio on aluminum steering arms
Optima on board motorcycle battery w/quick disconnect to Optima booster battery
Chain drive moved to left side for lightest arrangement (new 12t/55t sprockets)
Chrome moly gun bored rear axle assembly w/4 piston caliper
Biggest K&N air filters that would fit
Digatron 4 display data logger – RPM/MPH/L-EGT/R-EGT
4 aluminum trailing arms with aluminum panhard rod
2 gallon aluminum gas tank w/foam filler under the seat
Electric fuel pump w/switch and vacuum fuel pump (primes carbs before cold starting)
RR style master kill switch
New Polaris primary clutch, optimized setup & new clutch belt
Main roll hoop raised 4”
Partial Spares List
12 (6 front & 6 rear) R25 19.5x7.5 tires mounted/balanced on spun aluminum wheels
12 (6 front & 6 rear) R25 18.0x7.5 tires mounted/balanced on Kodiak aluminum wheels
4 (2 front & 2 rear) Rain 19.5x6.5 tires mounted/balanced on Kodiak aluminum wheels
1 spare (less carbs, starter, plug wires w/coil & MPEM) good condition Rotax 493 motor
1 complete Rotax 493 w/ poor compression on one cylinder (less carbs, starter, plug wires w/coil & MPEM)
Complete set for rebuilding a 493 – gaskets, seals, etc
Quick lift rear jack
Custom large pit cart that hitches to back of race car
Spare MPE
Set of about 20 Mikuni jets in board & carb tool kit
Polaris P85 used lightened primary clutch w/big bushing cover & starter ring
2 used starters
Spare calipers
Boxes of clutch tuning components and clutch tools
Mikuni tuning manual, clutch tuning manual
I also have a 7' x 14' enclosed trailer that I will sell with the car for an additional $3,200. Trailer was built in April of 2011.
Depending on your location, I may be willing to deliver.
Steve Hayward
585-298-3585
stevekh@rochester.rr.com