New DB6 rear deck for the Honda

[TimW]

As I mentioned in the previous thread, here are some photos of the deck Wava & Brian have ventured to make for us for the DB6/Honda conversions. I think these are pictures of the plug which will make the mold to pull parts from, not the part itself.

Note that the plug is just sitting on the car in the pictures, not fitted and attached so any gaps should be reduced in the final product.

Reach out to Wava on 262-375-1930 for more info

[RussMcB]

Very nice looking piece.

I called and spoke with Wava - very friendly. I asked about DB-3 fitment. She did not know, and mentioned they were interested to find out about DB-1 fitment. So, they might be looking for a DB-1 volunteer.

Or maybe someone already knows about engine cover interchangeablility between DB1 - DB3 - DB6?

[TimW]

Or maybe someone already knows about engine cover interchangeablility between DB1 - DB3 - DB6?

I think Porter's DB6s run DB1 bodywork, so would think you could go the other way. I would think that the reliefs for the wishbones would be slightly different for the rockers, but would bet it could be made to work with limited grinding.

You would also have to use the lower roll bar shroud though. But then the inlet would be made to fit too!