F1000 Exhaust

[Brands]

Hi
I have a new Brock Sidewinder Exhaust for sale. It is an 05-06 Suzuki GSXR 1000 unit but should fit in an F1000 car. I bought it for this job, but a friend hads offered to make me a Titanium unit for nothing using a lightly used Akrapovic system! Hence this one is for sale. With a low oil pan it will still be a little higher than the bottom of the motor, if that makes sense. It comes with headers, collectors and megaphone end can (with removeable baffle). It's pretty light at 7lbs without the baffle which adds 2lbs. You may need to mod it to fit individual applications though. It was expensive @ $1100. Any offers? Below is a little blurb from the Brock web site. I'll post some pics soon.



Uniquely constructed of an aerospace quality ultra-light weight stainless steel in a FOUR into TWO into ONE configuration for a smooth torque curve with a megaphone induced peak power punch! We have combined our knowledge gained over the years racing our hard launching StreetSmart Systems with a purpose built Race Megaphone.
A removable 2 ¼ outlet Billet Aluminum/stainless steel/fiberglass constructed baffle is included. As usual, our oversize tube design (Tapered 1 ¾” primaries meet DUAL 2” secondary pipes which merge into a velocity enhanced 2 ¼” collector) complements the ram air efficiency of the GSX-R1000. BIG engines and Nitrous bikes LOVE additional pipe volume. But, the tapered head pipes prevent lost bottom end power for a hard launch and maximum acceleration, even with a stock 1000 cc engine.

Tel: 404 642 2701.

e-mail. 1orange1@fsmail.net

Thanks

Ben

[Brands]

Pics!
Any offers?

[RobLav]

That might fit the Yamaha too. Looks like a nice piece.

[superbikestore]

Could you post the measurements of the headers where they fit to the engine - diameter of each fitting at the head and the center spacing of the pipes at the same surface (where they fit to the engine) - I have an R1 motor and wondered how far out they might be
Cheers
David

[Brands]

Exhaust dimensions. They are approximate but should be close enough to see if they will fit the R1. Also a pic of the muffler that's included. It has a billet insert that can be removed along with the baffle. Would look good sticking out the top of your sidepod!
Thanks

[Brands]

It's on ebay!!!


http://cgi.ebay.com/ebaymotors/ws/eB...9348215&rd=1,1

[Brands]

!!Sold!!