Search:

Cut a rectangular hole in each side, maybe 8" x 4" just about where your hips are and let in a joggled panel secured with rivets. As mentioned remove the fuel cells first!

I have seen several cars...

.

Afternoon Lee,

Well I finally made a bid for freedom.

F3000 2"-12 unified, F1 2"- 8 unified, F2 3/4"-16 unified & F3 M18 1.5 metric.

Everyone take care.

Nick.

Hello Lee.

Point well made. Certainly the thread pitch of the small axles is much finer than the large ones. Right now the shop is closed and being over 70 I am in solitary confinement at home....

Survey of cars in our workshop.

F3. Dallara F397, Dallara F398, Dallara F302, all small spindle, 115 lbs/ft, 4 drive pins all round.

F2. Toleman TG280, Toleman TG280, both small spindle, 115...

Now I check my Reynard 93 manual which is the similar size to Lola it actually recommends 450 lbs/ft.

You are going to be tightening the hub nuts to 400 lbs/ft which helps a little! Piece of advice. Always slacken off the nuts when you come in from a session, when cooled you will find it extremely...

Plenum chamber from 1988 Truesports Judd AV engine. $500.

Located in UK. Plus shipping at cost, or arrange courier pick up and I will pack it.

harrison.nh@mail.com + 44 7802 241711

Krutsi

Dallara went over to the FTR box in 2002 and with it sequential change. In F3 paddle change did not come until 2012 ( I think).

I run an H pattern Dallara (397) and it works well with a...

On our 94D there are two plates. The usual 'reynard racing cars ltd' plate on the left hand side of the tub just above the glue line. There is also a 'Reynard Composites' plate on the inside of the...

Hello Derek. This is a short bit of film made of a sales day at Castle Combe, maybe you are one of the drivers. Best regards, Nick.

http://www.britishpathe.com/video/formula-four-racing-cars

JW 4 is a Johnny Walker Formula 4. Go here for a lot of history.

http://forum.wscc.co.uk/forum/topic/104577-smokeys-jw4-formula-four-rebuild-thread/