If all else fails, try McMaster-Carr. They carry a range that looks like it will suit.
Type: Posts; User: JHerscher
If all else fails, try McMaster-Carr. They carry a range that looks like it will suit.
Good discussion here:
https://www.apexspeed.com/forums/showthread.php?14713-Bead-seat-vs-the-foam-seat
I run a mechanical fuel pump but as I understand it you must have a g-activated or oil pressure switch of some sort for an electric fuel pump. Make sure you can reset it from the cockpit.
I’ve...
Hey Stan
Thanks for the kind words, but the fact is that the only tires I had were used-up 2 1/2 year old A/R tires that weren't properly stored, showing cracking on the sidewalls, and good for...
Thumbs up for how a pair of Southeast Tire Suppliers - Appalachian Race Tire, and Performance Tread - responded to an issue.
This past weekend at Sebring, I had a horrible experience. The wrong...
I googled "enamel lola emblem" and this popped up.
https://www.lolaparts.co/copy-of-body-panels
No affiliation or experience, but maybe a source. Good luck.
I think the nose is Van Diemen RF98 or so. Check with Brad at Primus Racing Parts. He often has good used parts at fair prices.
Just today I had yet another example of the exemplary customer service I have experienced from Brad Baytos at Primus. Over the years, he has lent me parts to try out, located me stuff that I can't...
Sorry to maybe make this thread drift off topic but do I remember from years ago that FV engines needed valve lash checked/adjusted between sessions? I seem to recall seeing this as a routine...
On one of my cars I used lead weights that were 1"x1"x6" or so and built a locker for them on the floor. I think I had 5 or 6 or them and that they weighed about 2lbs each. I "tuned" the weight by...
obviously everyone is likely to have an opinion. so I will merely state my experience.
The first time I changed clutch slave cylinder o rings it was on my 94 VD. I used brake fluid as the...
The gelcoat will likely crack.
I would try to grind the inside of the area thin and push into the desired shape and reglass. Grind an area about 20mm square and enlarge as necessary.
Do it in...
Fiberglass “surfacing veil”, which is a very fine fiber non woven mat, is advertised as effective in reducing the telegraphing of fiberglass cloth through to the outer surface. It goes on as the...
No autocrosser here, but a 18 year FC driver. If you’re seriously looking at FC, I would think the shorter wheelbase of the early to mid 90s Van Diemen chassis would be better than later VD models....
Found you one. (I think!):D
...
These cars are fine with points and condenser. 25+ years and never used anything else.
Congratulations Steve!
Log books should have a record of any crash damage noted. That is assuming it was crashed when running in a sanctioned event requiring a log book entry.
John
Next time you're on a test & tune day, turn your in car camera on the suspension and see what the tufts of yarn you cleverly placed there are doing. Next session, fill in the gap with racers' tape,...
Maybe from a 412. Check out RockAuto.
John
Hi TF
No info on this helmet, but I use an unvented full face Bell in a FC in Florida in the summer. Absolutely no issues with lack of vents. Or buffeting for that matter.
But then I always...
http://solventkleene.com/Dzolve15.htm
No experience - I was curious too and did a little google research
John