Parting out small formula car

Printable View

01.14.23, 2:08 PM
B17overhead

1 Attachment(s)

Parting out small formula car

Parts left now with reduced pricing as well:

Complete carbureted Honda CBR600 F3 600cc with 4-into-1 header that looks to have been modified for formula car chassis. 100+ HP at 12,000 RPM with 4 carbs. Estimate 75-85 HP with FSAE restrictor and a single carb. Could be increased to 700 cc and probably over 90 HP now with latest FSAE rules. (All figures are for 100 unleaded, but probably no different for E85) Factory carbs and factory airbox with new air cleaner. Vance and Hines ignition electronics, complete harness and Autometer Tach. Includes chassis mounts/braces/rear chassis bulkhead for motor which allow it to sit upright on a flat surface.
Was $400, now $250.
Note $250 is about 50% of typical Ebay cost for this particular motor.
I'm not up for crating and shipping- now has to be a pickup or nearby by delivery by me.
01.14.23, 3:51 PM
Lastminuteracin

Message sent.
01.15.23, 8:04 PM
128racecar

PM sent
01.31.23, 8:27 AM
kingmotorsport

Are you willing to ship front end?

Quote:

Originally Posted by B17overhead

Parts left now:

Complete Honda 600cc. Factory carbs and airbox. Vance and Hines electronics, complete harness $400

New never used: Autometer gauges, 2604 2" mech oil pressure with tubing in original box with mounting hardware $10, 2635 2" temperature gauge - will need sender- in original box with mounting hardware $10

4 Keizer magnesium centers with 7 and 8 inch spun aluminum wheel halves. $275 each or 850 for all 4.
Alpha steering wheel. Like new

Both front corners
That would be a-arms, uprights with brakes, stub axles, and wheel hubs. $15 for all.
01.31.23, 11:11 AM
Earley Motorsports

Gauges

If you still have the gauges I'll take them. PM sent
01.31.23, 1:11 PM
B17overhead

.
02.15.24, 10:16 AM
10rmotor

Hey chuck if you still have the tach and its a pro cycle tach (14k?) I'm interested.
02.15.24, 2:49 PM
B17overhead

Quote:

Originally Posted by 10rmotor

Hey chuck if you still have the tach and its a pro cycle tach (14k?) I'm interested.

Think it went with the MC motor. I took one quick look just now and didn't see it. Look again later today.
02.15.24, 4:27 PM
Onebadbug

Bolt pattern on the wheels?
02.15.24, 5:43 PM
B17overhead

Quote:

Originally Posted by Onebadbug

Bolt pattern on the wheels?

Wheels are long gone. Sorry.
They were all 4x100mm Keizer lead anchor heavy alum centers and new Magnesium centers