wiring 2006-2007 gsx r600

Thoughts on disabling/eliminating
Side stand switch
Tip over sensor
Excva

Thanks,
Will

Quote:

---

Originally Posted by Vulnavia

Thoughts on disabling/eliminating
Side stand switch
Tip over sensor
Excva



Thanks,


Will

---

I would send the harness to hyper racing

Quote:

---

Originally Posted by clint

I would send the harness to hyper racing

---

I didn't drill down into any of the links on this page, but it looks like they have some good information:

(sorry. invalid link removed)

Here was my cheat sheet for the engine harness stuff. bottom is how to wire up the stuff for the starting and running. center section describes the different sensors. I didn't have the EXCVA on there for some reason but i think i just disconnected it and pulled one of the wires from the ecu plug.

basic things are:
clutch switch needs relay during start or you will be stuck in safe mode
side stand switch short
tip over needs a resistor as described below
ignition switch needs a resistor to simulate the key being in circuit

http://www.minibuggy.net/forum/contr...tml#post158256

https://www.apexspeed.com/forums/att...id=85483&stc=1

Very helpful.

Thank You

Will