1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    262,341
Page 4 of 126 FirstFirst 1234567814 ... LastLast
Threads 121 to 160 of 5003

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 289,207
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,326
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,420
    01.15.14, 9:36 AM Go to last post
  1. Master Cylinder Size Poll

    Started by Craig Henry, 02.11.05 12:07 PM
    • Replies: 8
    • Views: 2,338
    06.03.22, 10:13 PM Go to last post
  2. VD chassis production quantities

    Started by Rick Kirchner, 05.27.22 5:53 PM
    • Replies: 2
    • Views: 696
    05.27.22, 10:51 PM Go to last post
  3. Zetec high oil temp but water temp fine

    Started by shross, 05.27.22 10:07 AM
    • Replies: 5
    • Views: 658
    05.27.22, 5:51 PM Go to last post
    • Replies: 1
    • Views: 519
    05.25.22, 12:55 AM Go to last post
  4. Zetec FC oversized main bearings

    Started by E. Reed, 05.17.22 1:47 PM
    • Replies: 8
    • Views: 1,405
    05.23.22, 11:37 AM Go to last post
  5. Throwback Thursday part 22

    Started by Purple Frog, 11.25.20 10:40 PM
    • Replies: 13
    • Views: 3,116
    05.20.22, 12:11 AM Go to last post
  6. Owner of Elden MK28 FC?

    Started by lch Racing, 05.16.22 1:29 PM
    • Replies: 2
    • Views: 682
    05.16.22, 5:40 PM Go to last post
  7. Barber gears

    Started by Hartley, 05.10.22 2:03 PM
    • Replies: 6
    • Views: 911
    05.11.22, 10:33 AM Go to last post
  8. Pinto motor = tach killer?

    Started by JWMotorsports, 05.07.22 9:24 PM
    • Replies: 7
    • Views: 1,041
    05.09.22, 12:41 PM Go to last post
  9. Question for the zetec gurus

    Started by He49, 04.29.22 9:17 PM
    • Replies: 16
    • Views: 1,538
    05.06.22, 1:09 PM Go to last post
  10. FC excessive Spec Rear Tire Wear?

    Started by Skip Weld, 04.30.22 12:48 PM
    • Replies: 9
    • Views: 1,457
    05.05.22, 9:10 AM Go to last post
  11. Pinto vs zetec

    Started by Superjet800, 11.24.21 9:43 AM
    • Replies: 12
    • Views: 2,420
    05.04.22, 6:34 PM Go to last post
  12. Dynamic Dampers information?

    Started by glenn woloski, 04.28.22 11:23 AM
    • Replies: 3
    • Views: 620
    04.28.22, 4:06 PM Go to last post
  13. Van Diemen engine removal

    Started by John Green, 04.22.22 8:13 AM
    • Replies: 1
    • Views: 578
    04.22.22, 11:25 AM Go to last post
  14. Lookie What Arrived Today

    Started by Rick Iverson, 04.21.22 7:24 PM
    • Replies: 0
    • Views: 487
    04.21.22, 7:24 PM Go to last post
    • Replies: 23
    • Views: 2,087
    04.19.22, 4:45 PM Go to last post
  15. FC bias spec tire pressure question:

    Started by DaveW, 04.11.22 7:21 PM
    • Replies: 5
    • Views: 1,019
    04.16.22, 7:03 PM Go to last post
  16. Correct Hoosier rear rain tire??

    Started by tahoe z, 04.09.22 10:21 PM
    • Replies: 3
    • Views: 698
    04.10.22, 9:11 PM Go to last post
  17. F C flywheel unavailable?

    Started by glenn woloski, 04.07.22 1:31 PM
    • Replies: 4
    • Views: 990
    04.08.22, 8:04 PM Go to last post
  18. Wilwood WLD20 Aluminum Caliper

    Started by BrianT1, 03.27.22 2:30 PM
    • Replies: 20
    • Views: 2,121
    04.05.22, 11:52 AM Go to last post
  19. PFC Brake Caliper/Pads

    Started by cliff, 03.29.22 2:51 PM
    • Replies: 13
    • Views: 1,363
    04.04.22, 5:17 PM Go to last post
  20. Oil lines

    Started by BrianT1, 03.27.22 9:04 PM
    • Replies: 1
    • Views: 414
    03.28.22, 2:16 AM Go to last post
  21. Zetec alternator question

    Started by Lotus7, 03.05.22 3:38 PM
    • Replies: 30
    • Views: 2,693
    03.27.22, 11:14 AM Go to last post
  22. Girling copper o-rings

    Started by beavertail, 03.18.22 8:18 AM
    • Replies: 4
    • Views: 690
    03.18.22, 7:28 PM Go to last post
  23. Brake Rotor Identifcation

    Started by BeerBudgetRacing, 03.15.22 2:53 AM
    • Replies: 6
    • Views: 1,070
    03.17.22, 10:11 AM Go to last post
  24. Wide gear install in LD200

    Started by Sutherland70, 03.10.22 9:28 AM
    • Replies: 8
    • Views: 914
    03.14.22, 9:08 PM Go to last post
  25. Hewland gears and Staffs reverse gear parts

    Started by DaveW, 03.09.22 4:37 PM
    • Replies: 0
    • Views: 367
    03.09.22, 4:37 PM Go to last post
  26. Pinto fuel pump

    Started by lucky13, 03.03.22 1:13 PM
    • Replies: 16
    • Views: 1,546
    03.05.22, 11:47 AM Go to last post
  27. New member with Argo JM17FC

    Started by Cpines, 06.27.21 8:56 PM
    • Replies: 29
    • Views: 3,826
    03.03.22, 10:02 PM Go to last post
  28. RF-94/95 F&R Tracks

    Started by Rick Iverson, 02.25.22 7:13 PM
    • Replies: 0
    • Views: 477
    02.25.22, 7:13 PM Go to last post
  29. New to me RF94

    Started by Octonion, 07.28.21 1:15 PM
    2 Pages
    1 2
    • Replies: 49
    • Views: 7,349
    02.25.22, 10:38 AM Go to last post
  30. RF-95 Aluminum Tripod Housings

    Started by Rick Iverson, 02.24.22 12:34 PM
    • Replies: 1
    • Views: 439
    02.24.22, 3:16 PM Go to last post
  31. Pinto coolant flow direction?

    Started by SteveG, 02.18.22 9:34 PM
    • Replies: 7
    • Views: 1,120
    02.19.22, 5:36 PM Go to last post
    • Replies: 18
    • Views: 1,726
    02.17.22, 6:53 PM Go to last post
  32. FE2 vs FC

    Started by andyllc, 11.11.21 10:16 PM
    • Replies: 20
    • Views: 3,247
    02.16.22, 1:53 PM Go to last post
  33. Loosening Pinto head bolts

    Started by Michael Lensen, 02.15.22 11:12 PM
    • Replies: 4
    • Views: 633
    02.16.22, 10:30 AM Go to last post
  34. FC Tire weight difference?

    Started by Lotus7, 02.11.22 2:12 PM
    • Replies: 6
    • Views: 854
    02.15.22, 10:14 AM Go to last post
  35. Zetec Accessory Belt w/ dynamo kit

    Started by BeerBudgetRacing, 02.01.22 2:41 AM
    • Replies: 11
    • Views: 928
    02.03.22, 2:54 PM Go to last post
  36. LD-200 End Plate Mounts

    Started by Rick Iverson, 01.29.22 8:04 PM
    • Replies: 5
    • Views: 691
    01.30.22, 8:12 PM Go to last post
  37. Moved: Brad Baytos - Update

    Started by CScharnow, 01.21.22 12:05 PM
    •  
    •  

Page 4 of 126 FirstFirst 1234567814 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 33 users browsing this forum. (0 members & 33 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social