1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    262,720
Page 4 of 126 FirstFirst 1234567814 ... LastLast
Threads 121 to 160 of 5004

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 289,332
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,368
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,466
    01.15.14, 9:36 AM Go to last post
  1. Broken Rear Hub

    Started by ejsprint30, 06.20.22 5:42 PM
    • Replies: 16
    • Views: 1,772
    06.21.22, 5:48 PM Go to last post
  2. Master Cylinder Size Poll

    Started by Craig Henry, 02.11.05 12:07 PM
    • Replies: 8
    • Views: 2,340
    06.03.22, 10:13 PM Go to last post
  3. VD chassis production quantities

    Started by Rick Kirchner, 05.27.22 5:53 PM
    • Replies: 2
    • Views: 698
    05.27.22, 10:51 PM Go to last post
  4. Zetec high oil temp but water temp fine

    Started by shross, 05.27.22 10:07 AM
    • Replies: 5
    • Views: 659
    05.27.22, 5:51 PM Go to last post
    • Replies: 1
    • Views: 519
    05.25.22, 12:55 AM Go to last post
  5. Zetec FC oversized main bearings

    Started by E. Reed, 05.17.22 1:47 PM
    • Replies: 8
    • Views: 1,411
    05.23.22, 11:37 AM Go to last post
  6. Throwback Thursday part 22

    Started by Purple Frog, 11.25.20 10:40 PM
    • Replies: 13
    • Views: 3,121
    05.20.22, 12:11 AM Go to last post
  7. Owner of Elden MK28 FC?

    Started by lch Racing, 05.16.22 1:29 PM
    • Replies: 2
    • Views: 686
    05.16.22, 5:40 PM Go to last post
  8. Barber gears

    Started by Hartley, 05.10.22 2:03 PM
    • Replies: 6
    • Views: 937
    05.11.22, 10:33 AM Go to last post
  9. Pinto motor = tach killer?

    Started by JWMotorsports, 05.07.22 9:24 PM
    • Replies: 7
    • Views: 1,044
    05.09.22, 12:41 PM Go to last post
  10. Question for the zetec gurus

    Started by He49, 04.29.22 9:17 PM
    • Replies: 16
    • Views: 1,539
    05.06.22, 1:09 PM Go to last post
  11. FC excessive Spec Rear Tire Wear?

    Started by Skip Weld, 04.30.22 12:48 PM
    • Replies: 9
    • Views: 1,460
    05.05.22, 9:10 AM Go to last post
  12. Pinto vs zetec

    Started by Superjet800, 11.24.21 9:43 AM
    • Replies: 12
    • Views: 2,468
    05.04.22, 6:34 PM Go to last post
  13. Dynamic Dampers information?

    Started by glenn woloski, 04.28.22 11:23 AM
    • Replies: 3
    • Views: 623
    04.28.22, 4:06 PM Go to last post
  14. Van Diemen engine removal

    Started by John Green, 04.22.22 8:13 AM
    • Replies: 1
    • Views: 582
    04.22.22, 11:25 AM Go to last post
  15. Lookie What Arrived Today

    Started by Rick Iverson, 04.21.22 7:24 PM
    • Replies: 0
    • Views: 490
    04.21.22, 7:24 PM Go to last post
    • Replies: 23
    • Views: 2,093
    04.19.22, 4:45 PM Go to last post
  16. FC bias spec tire pressure question:

    Started by DaveW, 04.11.22 7:21 PM
    • Replies: 5
    • Views: 1,022
    04.16.22, 7:03 PM Go to last post
  17. Correct Hoosier rear rain tire??

    Started by tahoe z, 04.09.22 10:21 PM
    • Replies: 3
    • Views: 701
    04.10.22, 9:11 PM Go to last post
  18. F C flywheel unavailable?

    Started by glenn woloski, 04.07.22 1:31 PM
    • Replies: 4
    • Views: 994
    04.08.22, 8:04 PM Go to last post
  19. Wilwood WLD20 Aluminum Caliper

    Started by BrianT1, 03.27.22 2:30 PM
    • Replies: 20
    • Views: 2,127
    04.05.22, 11:52 AM Go to last post
  20. PFC Brake Caliper/Pads

    Started by cliff, 03.29.22 2:51 PM
    • Replies: 13
    • Views: 1,367
    04.04.22, 5:17 PM Go to last post
  21. Oil lines

    Started by BrianT1, 03.27.22 9:04 PM
    • Replies: 1
    • Views: 424
    03.28.22, 2:16 AM Go to last post
  22. Zetec alternator question

    Started by Lotus7, 03.05.22 3:38 PM
    • Replies: 30
    • Views: 2,696
    03.27.22, 11:14 AM Go to last post
  23. Girling copper o-rings

    Started by beavertail, 03.18.22 8:18 AM
    • Replies: 4
    • Views: 694
    03.18.22, 7:28 PM Go to last post
  24. Brake Rotor Identifcation

    Started by BeerBudgetRacing, 03.15.22 2:53 AM
    • Replies: 6
    • Views: 1,074
    03.17.22, 10:11 AM Go to last post
  25. Wide gear install in LD200

    Started by Sutherland70, 03.10.22 9:28 AM
    • Replies: 8
    • Views: 918
    03.14.22, 9:08 PM Go to last post
  26. Hewland gears and Staffs reverse gear parts

    Started by DaveW, 03.09.22 4:37 PM
    • Replies: 0
    • Views: 367
    03.09.22, 4:37 PM Go to last post
  27. Pinto fuel pump

    Started by lucky13, 03.03.22 1:13 PM
    • Replies: 16
    • Views: 1,601
    03.05.22, 11:47 AM Go to last post
  28. New member with Argo JM17FC

    Started by Cpines, 06.27.21 8:56 PM
    • Replies: 29
    • Views: 3,829
    03.03.22, 10:02 PM Go to last post
  29. RF-94/95 F&R Tracks

    Started by Rick Iverson, 02.25.22 7:13 PM
    • Replies: 0
    • Views: 479
    02.25.22, 7:13 PM Go to last post
  30. New to me RF94

    Started by Octonion, 07.28.21 1:15 PM
    2 Pages
    1 2
    • Replies: 49
    • Views: 7,519
    02.25.22, 10:38 AM Go to last post
  31. RF-95 Aluminum Tripod Housings

    Started by Rick Iverson, 02.24.22 12:34 PM
    • Replies: 1
    • Views: 442
    02.24.22, 3:16 PM Go to last post
  32. Pinto coolant flow direction?

    Started by SteveG, 02.18.22 9:34 PM
    • Replies: 7
    • Views: 1,128
    02.19.22, 5:36 PM Go to last post
    • Replies: 18
    • Views: 1,729
    02.17.22, 6:53 PM Go to last post
  33. FE2 vs FC

    Started by andyllc, 11.11.21 10:16 PM
    • Replies: 20
    • Views: 3,319
    02.16.22, 1:53 PM Go to last post
  34. Loosening Pinto head bolts

    Started by Michael Lensen, 02.15.22 11:12 PM
    • Replies: 4
    • Views: 637
    02.16.22, 10:30 AM Go to last post
  35. FC Tire weight difference?

    Started by Lotus7, 02.11.22 2:12 PM
    • Replies: 6
    • Views: 857
    02.15.22, 10:14 AM Go to last post
  36. Zetec Accessory Belt w/ dynamo kit

    Started by BeerBudgetRacing, 02.01.22 2:41 AM
    • Replies: 11
    • Views: 929
    02.03.22, 2:54 PM Go to last post
  37. LD-200 End Plate Mounts

    Started by Rick Iverson, 01.29.22 8:04 PM
    • Replies: 5
    • Views: 696
    01.30.22, 8:12 PM Go to last post

Page 4 of 126 FirstFirst 1234567814 ... LastLast

Forum Information and Options

Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social