1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    262,314
Page 2 of 126 FirstFirst 12345612 ... LastLast
Threads 41 to 80 of 5003

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 289,187
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,319
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,413
    01.15.14, 9:36 AM Go to last post
  1. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,487
    09.10.23, 9:52 PM Go to last post
  2. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 558
    08.22.23, 7:36 PM Go to last post
  3. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 1,050
    08.05.23, 12:19 PM Go to last post
  4. 1985 Reynard spring rates

    Started by JWMotorsports, 07.30.23 8:56 PM
    • Replies: 4
    • Views: 804
    08.01.23, 4:44 AM Go to last post
  5. 2022-2023 entries

    Started by John LaRue, 07.11.23 2:32 PM
    • Replies: 34
    • Views: 3,495
    07.18.23, 5:20 PM Go to last post
  6. VD owner in Philadelphia/Allentown PA area

    Started by mwalsh, 07.04.23 10:22 PM
    • Replies: 2
    • Views: 954
    07.13.23, 11:25 AM Go to last post
  7. FC Questions

    Started by gmaloy, 07.05.23 11:13 AM
    • Replies: 14
    • Views: 2,142
    07.07.23, 10:34 PM Go to last post
  8. Fuel Cell

    Started by Rick Iverson, 07.01.23 6:09 PM
    • Replies: 18
    • Views: 1,989
    07.04.23, 7:47 AM Go to last post
  9. Ld200 parts

    Started by ewcmr2, 06.28.23 5:47 PM
    • Replies: 5
    • Views: 867
    06.30.23, 2:09 PM Go to last post
  10. Block crack on top bell housing tab

    Started by upnorthelan, 06.27.23 11:10 AM
    • Replies: 11
    • Views: 1,161
    06.29.23, 1:16 AM Go to last post
  11. Bearing Removal

    Started by Rick Iverson, 05.19.23 7:30 PM
    • Replies: 2
    • Views: 996
    06.28.23, 10:25 PM Go to last post
  12. Remove body side panels

    Started by mwalsh, 06.12.23 10:27 PM
    • Replies: 15
    • Views: 1,576
    06.16.23, 1:30 PM Go to last post
  13. Overheating question.

    Started by mwalsh, 06.13.23 10:14 PM
    • Replies: 1
    • Views: 555
    06.13.23, 11:32 PM Go to last post
  14. Noob question about oil changes

    Started by mwalsh, 06.08.23 10:47 PM
    • Replies: 5
    • Views: 950
    06.12.23, 10:28 PM Go to last post
  15. Zetec Fuel Pressure Regulator O-ring

    Started by Jon Jeffords, 05.28.23 9:38 AM
    • Replies: 4
    • Views: 794
    05.31.23, 8:03 PM Go to last post
  16. ECU location in an RF01?

    Started by BeerBudgetRacing, 05.07.23 5:03 PM
    • Replies: 8
    • Views: 1,305
    05.18.23, 12:30 PM Go to last post
  17. Fuel settings for FRP MZR fuel map

    Started by Redawgleader, 05.15.23 6:17 PM
    • Replies: 0
    • Views: 577
    05.15.23, 6:17 PM Go to last post
  18. Ride Height Measurement Points

    Started by Rick Iverson, 05.06.23 8:08 PM
    • Replies: 5
    • Views: 1,107
    05.07.23, 2:55 PM Go to last post
  19. AP LD20 calipers vs Wilwood

    Started by Monte, 05.02.23 11:53 AM
    • Replies: 19
    • Views: 2,104
    05.06.23, 4:12 PM Go to last post
  20. Zetec Flywheel Protection?

    Started by Lyngengr, 04.17.23 12:26 PM
    • Replies: 14
    • Views: 1,712
    05.02.23, 11:29 AM Go to last post
  21. Bolt Map

    Started by Rick Iverson, 04.26.23 11:07 AM
    • Replies: 0
    • Views: 803
    04.26.23, 11:07 AM Go to last post
    • Replies: 6
    • Views: 1,091
    04.22.23, 1:39 PM Go to last post
  22. TPS Sensor for Zetec

    Started by gavinaitken, 11.16.16 1:09 PM
    • Replies: 11
    • Views: 3,195
    04.20.23, 9:09 PM Go to last post
  23. Micron 5 RPM accuracy

    Started by J Weida, 04.16.23 5:04 PM
    • Replies: 4
    • Views: 904
    04.16.23, 11:34 PM Go to last post
  24. Zetec Crank Sensor

    Started by quickmag, 04.14.23 12:55 PM
    • Replies: 5
    • Views: 799
    04.14.23, 5:42 PM Go to last post
  25. 3D printable FC Models

    Started by RSS, 02.17.22 7:15 PM
    • Replies: 19
    • Views: 3,744
    04.10.23, 2:19 PM Go to last post
  26. Rubber versus Steel Brake Lines

    Started by racpercival, 03.12.23 1:31 AM
    • Replies: 5
    • Views: 1,156
    03.30.23, 6:28 PM Go to last post
  27. Carb question?

    Started by pcarnut, 03.28.23 3:28 PM
    • Replies: 2
    • Views: 1,028
    03.30.23, 4:09 PM Go to last post
  28. Looking for Van Diemen wheel

    Started by FormulaC44, 03.21.23 11:55 AM
    • Replies: 3
    • Views: 767
    03.28.23, 3:11 PM Go to last post
  29. FC/F2000 Ad Hoc Committee

    Started by John LaRue, 02.11.20 4:53 PM
    • Replies: 33
    • Views: 8,028
    03.28.23, 9:57 AM Go to last post
  30. Pertronix Distributor

    Started by John Green, 03.20.23 6:00 PM
    • Replies: 2
    • Views: 556
    03.20.23, 7:48 PM Go to last post
  31. FC Car Manufacturers

    Started by Goallie11, 01.30.23 1:40 PM
    • Replies: 11
    • Views: 1,611
    03.20.23, 6:45 PM Go to last post
  32. Spring size

    Started by Hartley, 02.25.23 11:10 AM
    • Replies: 14
    • Views: 1,691
    02.28.23, 1:45 PM Go to last post
  33. 32/36 differences

    Started by JHerscher, 02.18.23 5:07 PM
    • Replies: 3
    • Views: 886
    02.23.23, 8:20 PM Go to last post
  34. Caliper Mounting Bolt Torque

    Started by BeerBudgetRacing, 02.12.23 3:25 PM
    • Replies: 11
    • Views: 1,464
    02.18.23, 5:07 PM Go to last post
  35. Van Diemen Track specs

    Started by John Green, 02.16.23 4:26 PM
    • Replies: 2
    • Views: 726
    02.17.23, 9:07 PM Go to last post
    • Replies: 10
    • Views: 1,554
    02.09.23, 1:03 PM Go to last post
  36. 2.0 Ford motor parts

    Started by kulachd, 02.07.23 1:43 PM
    • Replies: 7
    • Views: 877
    02.07.23, 10:56 PM Go to last post
  37. Sticky Piston

    Started by Steve Demeter, 01.29.23 6:19 PM
    • Replies: 25
    • Views: 2,403
    02.07.23, 1:06 AM Go to last post
  38. Source for Pinto parts

    Started by MrJackson, 02.04.23 8:03 PM
    • Replies: 1
    • Views: 481
    02.05.23, 6:35 PM Go to last post

Page 2 of 126 FirstFirst 12345612 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 36 users browsing this forum. (4 members & 32 guests)

  1. BrianT1,
  2. Cameron Wagner,
  3. CARSHouston,
  4. Krankycraner

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social