1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    262,758
Page 2 of 126 FirstFirst 12345612 ... LastLast
Threads 41 to 80 of 5004

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 289,343
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,373
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,471
    01.15.14, 9:36 AM Go to last post
  1. Zetec fuel pressure

    Started by quickmag, 09.28.23 7:50 PM
    • Replies: 4
    • Views: 862
    09.30.23, 1:16 PM Go to last post
  2. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,505
    09.10.23, 9:52 PM Go to last post
  3. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 575
    08.22.23, 7:36 PM Go to last post
  4. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 1,068
    08.05.23, 12:19 PM Go to last post
  5. 1985 Reynard spring rates

    Started by JWMotorsports, 07.30.23 8:56 PM
    • Replies: 4
    • Views: 825
    08.01.23, 4:44 AM Go to last post
  6. 2022-2023 entries

    Started by John LaRue, 07.11.23 2:32 PM
    • Replies: 34
    • Views: 3,518
    07.18.23, 5:20 PM Go to last post
  7. VD owner in Philadelphia/Allentown PA area

    Started by mwalsh, 07.04.23 10:22 PM
    • Replies: 2
    • Views: 973
    07.13.23, 11:25 AM Go to last post
  8. FC Questions

    Started by gmaloy, 07.05.23 11:13 AM
    • Replies: 14
    • Views: 2,195
    07.07.23, 10:34 PM Go to last post
  9. Fuel Cell

    Started by Rick Iverson, 07.01.23 6:09 PM
    • Replies: 18
    • Views: 2,052
    07.04.23, 7:47 AM Go to last post
  10. Ld200 parts

    Started by ewcmr2, 06.28.23 5:47 PM
    • Replies: 5
    • Views: 889
    06.30.23, 2:09 PM Go to last post
  11. Block crack on top bell housing tab

    Started by upnorthelan, 06.27.23 11:10 AM
    • Replies: 11
    • Views: 1,164
    06.29.23, 1:16 AM Go to last post
  12. Bearing Removal

    Started by Rick Iverson, 05.19.23 7:30 PM
    • Replies: 2
    • Views: 1,007
    06.28.23, 10:25 PM Go to last post
  13. Remove body side panels

    Started by mwalsh, 06.12.23 10:27 PM
    • Replies: 15
    • Views: 1,584
    06.16.23, 1:30 PM Go to last post
  14. Overheating question.

    Started by mwalsh, 06.13.23 10:14 PM
    • Replies: 1
    • Views: 560
    06.13.23, 11:32 PM Go to last post
  15. Noob question about oil changes

    Started by mwalsh, 06.08.23 10:47 PM
    • Replies: 5
    • Views: 952
    06.12.23, 10:28 PM Go to last post
  16. Zetec Fuel Pressure Regulator O-ring

    Started by Jon Jeffords, 05.28.23 9:38 AM
    • Replies: 4
    • Views: 797
    05.31.23, 8:03 PM Go to last post
  17. ECU location in an RF01?

    Started by BeerBudgetRacing, 05.07.23 5:03 PM
    • Replies: 8
    • Views: 1,310
    05.18.23, 12:30 PM Go to last post
  18. Fuel settings for FRP MZR fuel map

    Started by Redawgleader, 05.15.23 6:17 PM
    • Replies: 0
    • Views: 582
    05.15.23, 6:17 PM Go to last post
  19. Ride Height Measurement Points

    Started by Rick Iverson, 05.06.23 8:08 PM
    • Replies: 5
    • Views: 1,110
    05.07.23, 2:55 PM Go to last post
  20. AP LD20 calipers vs Wilwood

    Started by Monte, 05.02.23 11:53 AM
    • Replies: 19
    • Views: 2,115
    05.06.23, 4:12 PM Go to last post
  21. Zetec Flywheel Protection?

    Started by Lyngengr, 04.17.23 12:26 PM
    • Replies: 14
    • Views: 1,718
    05.02.23, 11:29 AM Go to last post
  22. Bolt Map

    Started by Rick Iverson, 04.26.23 11:07 AM
    • Replies: 0
    • Views: 810
    04.26.23, 11:07 AM Go to last post
    • Replies: 6
    • Views: 1,092
    04.22.23, 1:39 PM Go to last post
  23. TPS Sensor for Zetec

    Started by gavinaitken, 11.16.16 1:09 PM
    • Replies: 11
    • Views: 3,201
    04.20.23, 9:09 PM Go to last post
  24. Micron 5 RPM accuracy

    Started by J Weida, 04.16.23 5:04 PM
    • Replies: 4
    • Views: 909
    04.16.23, 11:34 PM Go to last post
  25. Zetec Crank Sensor

    Started by quickmag, 04.14.23 12:55 PM
    • Replies: 5
    • Views: 802
    04.14.23, 5:42 PM Go to last post
  26. 3D printable FC Models

    Started by RSS, 02.17.22 7:15 PM
    • Replies: 19
    • Views: 3,749
    04.10.23, 2:19 PM Go to last post
  27. Rubber versus Steel Brake Lines

    Started by racpercival, 03.12.23 1:31 AM
    • Replies: 5
    • Views: 1,159
    03.30.23, 6:28 PM Go to last post
  28. Carb question?

    Started by pcarnut, 03.28.23 3:28 PM
    • Replies: 2
    • Views: 1,042
    03.30.23, 4:09 PM Go to last post
  29. Looking for Van Diemen wheel

    Started by FormulaC44, 03.21.23 11:55 AM
    • Replies: 3
    • Views: 769
    03.28.23, 3:11 PM Go to last post
  30. FC/F2000 Ad Hoc Committee

    Started by John LaRue, 02.11.20 4:53 PM
    • Replies: 33
    • Views: 8,036
    03.28.23, 9:57 AM Go to last post
  31. Pertronix Distributor

    Started by John Green, 03.20.23 6:00 PM
    • Replies: 2
    • Views: 560
    03.20.23, 7:48 PM Go to last post
  32. FC Car Manufacturers

    Started by Goallie11, 01.30.23 1:40 PM
    • Replies: 11
    • Views: 1,615
    03.20.23, 6:45 PM Go to last post
  33. Spring size

    Started by Hartley, 02.25.23 11:10 AM
    • Replies: 14
    • Views: 1,740
    02.28.23, 1:45 PM Go to last post
  34. 32/36 differences

    Started by JHerscher, 02.18.23 5:07 PM
    • Replies: 3
    • Views: 890
    02.23.23, 8:20 PM Go to last post
  35. Caliper Mounting Bolt Torque

    Started by BeerBudgetRacing, 02.12.23 3:25 PM
    • Replies: 11
    • Views: 1,472
    02.18.23, 5:07 PM Go to last post
  36. Van Diemen Track specs

    Started by John Green, 02.16.23 4:26 PM
    • Replies: 2
    • Views: 731
    02.17.23, 9:07 PM Go to last post
    • Replies: 10
    • Views: 1,556
    02.09.23, 1:03 PM Go to last post
  37. 2.0 Ford motor parts

    Started by kulachd, 02.07.23 1:43 PM
    • Replies: 7
    • Views: 883
    02.07.23, 10:56 PM Go to last post
  38. Sticky Piston

    Started by Steve Demeter, 01.29.23 6:19 PM
    • Replies: 25
    • Views: 2,485
    02.07.23, 1:06 AM Go to last post

Page 2 of 126 FirstFirst 12345612 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 37 users browsing this forum. (3 members & 34 guests)

  1. Lastminuteracin,
  2. Pacer Racer,
  3. T-Tom

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social