1. Announcement:
    No Political Comments & Commentary
    dc (Administrator)
    09.28.16
    Views:
    263,541
Page 2 of 126 FirstFirst 12345612 ... LastLast
Threads 41 to 80 of 5005

Forum: FC: General Discussion

Open content and general conversation about national and club racing.

  1. Sticky Thread Sticky: The Perpetual "What Gearing Do I Run at This Track?" Thread

    Started by Keith Carter, 06.01.05 7:01 PM
    5 Pages
    1 2 3 4 5
    • Replies: 178
    • Views: 291,919
    07.17.23, 9:43 AM Go to last post
  2. Sticky Thread Sticky: Baseline Gearing and Setup Sheet

    Started by Keith Carter, 04.29.05 1:54 AM
    2 Pages
    1 2
    • Replies: 45
    • Views: 58,533
    03.09.15, 6:41 PM Go to last post
  3. Sticky Thread Sticky: ApexSpeed.com Donations

    Started by dc, 03.20.03 12:16 AM
    2 Pages
    1 2
    • Replies: 43
    • Views: 40,621
    01.15.14, 9:36 AM Go to last post
  1. 96 vd test fit

    Started by djones, 10.04.23 6:09 PM
    • Replies: 7
    • Views: 1,173
    10.06.23, 5:36 PM Go to last post
  2. Zetec fuel pressure

    Started by quickmag, 09.28.23 7:50 PM
    • Replies: 4
    • Views: 876
    09.30.23, 1:16 PM Go to last post
  3. Dynamic Damper Can Pressure

    Started by Lyngengr, 08.22.23 11:57 AM
    • Replies: 10
    • Views: 1,515
    09.10.23, 9:52 PM Go to last post
  4. Rebuild

    Started by Rick Iverson, 08.22.23 7:36 PM
    • Replies: 0
    • Views: 581
    08.22.23, 7:36 PM Go to last post
  5. Input Shaft Tube Seal in Oil Tank

    Started by Bob Coury, 06.25.23 10:27 AM
    • Replies: 7
    • Views: 1,081
    08.05.23, 12:19 PM Go to last post
  6. 1985 Reynard spring rates

    Started by JWMotorsports, 07.30.23 8:56 PM
    • Replies: 4
    • Views: 836
    08.01.23, 4:44 AM Go to last post
  7. 2022-2023 entries

    Started by John LaRue, 07.11.23 2:32 PM
    • Replies: 34
    • Views: 3,540
    07.18.23, 5:20 PM Go to last post
  8. VD owner in Philadelphia/Allentown PA area

    Started by mwalsh, 07.04.23 10:22 PM
    • Replies: 2
    • Views: 986
    07.13.23, 11:25 AM Go to last post
  9. FC Questions

    Started by gmaloy, 07.05.23 11:13 AM
    • Replies: 14
    • Views: 2,202
    07.07.23, 10:34 PM Go to last post
  10. Fuel Cell

    Started by Rick Iverson, 07.01.23 6:09 PM
    • Replies: 18
    • Views: 2,077
    07.04.23, 7:47 AM Go to last post
  11. Ld200 parts

    Started by ewcmr2, 06.28.23 5:47 PM
    • Replies: 5
    • Views: 897
    06.30.23, 2:09 PM Go to last post
  12. Block crack on top bell housing tab

    Started by upnorthelan, 06.27.23 11:10 AM
    • Replies: 11
    • Views: 1,169
    06.29.23, 1:16 AM Go to last post
  13. Bearing Removal

    Started by Rick Iverson, 05.19.23 7:30 PM
    • Replies: 2
    • Views: 1,015
    06.28.23, 10:25 PM Go to last post
  14. Remove body side panels

    Started by mwalsh, 06.12.23 10:27 PM
    • Replies: 15
    • Views: 1,610
    06.16.23, 1:30 PM Go to last post
  15. Overheating question.

    Started by mwalsh, 06.13.23 10:14 PM
    • Replies: 1
    • Views: 564
    06.13.23, 11:32 PM Go to last post
  16. Noob question about oil changes

    Started by mwalsh, 06.08.23 10:47 PM
    • Replies: 5
    • Views: 965
    06.12.23, 10:28 PM Go to last post
  17. Zetec Fuel Pressure Regulator O-ring

    Started by Jon Jeffords, 05.28.23 9:38 AM
    • Replies: 4
    • Views: 798
    05.31.23, 8:03 PM Go to last post
  18. ECU location in an RF01?

    Started by BeerBudgetRacing, 05.07.23 5:03 PM
    • Replies: 8
    • Views: 1,316
    05.18.23, 12:30 PM Go to last post
  19. Fuel settings for FRP MZR fuel map

    Started by Redawgleader, 05.15.23 6:17 PM
    • Replies: 0
    • Views: 585
    05.15.23, 6:17 PM Go to last post
  20. Ride Height Measurement Points

    Started by Rick Iverson, 05.06.23 8:08 PM
    • Replies: 5
    • Views: 1,121
    05.07.23, 2:55 PM Go to last post
  21. AP LD20 calipers vs Wilwood

    Started by Monte, 05.02.23 11:53 AM
    • Replies: 19
    • Views: 2,142
    05.06.23, 4:12 PM Go to last post
  22. Zetec Flywheel Protection?

    Started by Lyngengr, 04.17.23 12:26 PM
    • Replies: 14
    • Views: 1,751
    05.02.23, 11:29 AM Go to last post
  23. Bolt Map

    Started by Rick Iverson, 04.26.23 11:07 AM
    • Replies: 0
    • Views: 814
    04.26.23, 11:07 AM Go to last post
    • Replies: 6
    • Views: 1,102
    04.22.23, 1:39 PM Go to last post
  24. TPS Sensor for Zetec

    Started by gavinaitken, 11.16.16 1:09 PM
    • Replies: 11
    • Views: 3,204
    04.20.23, 9:09 PM Go to last post
  25. Micron 5 RPM accuracy

    Started by J Weida, 04.16.23 5:04 PM
    • Replies: 4
    • Views: 919
    04.16.23, 11:34 PM Go to last post
  26. Zetec Crank Sensor

    Started by quickmag, 04.14.23 12:55 PM
    • Replies: 5
    • Views: 810
    04.14.23, 5:42 PM Go to last post
  27. 3D printable FC Models

    Started by RSS, 02.17.22 7:15 PM
    • Replies: 19
    • Views: 3,783
    04.10.23, 2:19 PM Go to last post
  28. Rubber versus Steel Brake Lines

    Started by racpercival, 03.12.23 1:31 AM
    • Replies: 5
    • Views: 1,162
    03.30.23, 6:28 PM Go to last post
  29. Carb question?

    Started by pcarnut, 03.28.23 3:28 PM
    • Replies: 2
    • Views: 1,043
    03.30.23, 4:09 PM Go to last post
  30. Looking for Van Diemen wheel

    Started by FormulaC44, 03.21.23 11:55 AM
    • Replies: 3
    • Views: 769
    03.28.23, 3:11 PM Go to last post
  31. FC/F2000 Ad Hoc Committee

    Started by John LaRue, 02.11.20 4:53 PM
    • Replies: 33
    • Views: 8,040
    03.28.23, 9:57 AM Go to last post
  32. Pertronix Distributor

    Started by John Green, 03.20.23 6:00 PM
    • Replies: 2
    • Views: 561
    03.20.23, 7:48 PM Go to last post
  33. FC Car Manufacturers

    Started by Goallie11, 01.30.23 1:40 PM
    • Replies: 11
    • Views: 1,629
    03.20.23, 6:45 PM Go to last post
  34. Spring size

    Started by Hartley, 02.25.23 11:10 AM
    • Replies: 14
    • Views: 1,742
    02.28.23, 1:45 PM Go to last post
  35. 32/36 differences

    Started by JHerscher, 02.18.23 5:07 PM
    • Replies: 3
    • Views: 891
    02.23.23, 8:20 PM Go to last post
  36. Caliper Mounting Bolt Torque

    Started by BeerBudgetRacing, 02.12.23 3:25 PM
    • Replies: 11
    • Views: 1,492
    02.18.23, 5:07 PM Go to last post
  37. Van Diemen Track specs

    Started by John Green, 02.16.23 4:26 PM
    • Replies: 2
    • Views: 739
    02.17.23, 9:07 PM Go to last post
    • Replies: 10
    • Views: 1,575
    02.09.23, 1:03 PM Go to last post
  38. 2.0 Ford motor parts

    Started by kulachd, 02.07.23 1:43 PM
    • Replies: 7
    • Views: 897
    02.07.23, 10:56 PM Go to last post

Page 2 of 126 FirstFirst 12345612 ... LastLast

Forum Information and Options

Users Browsing this Forum

There are currently 38 users browsing this forum. (3 members & 35 guests)

  1. albinoferret,
  2. Scott Bergan,
  3. scott fairchild

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  




About Us
Since 2000, ApexSpeed.com has been the go-to place for amateur road racing enthusiasts, bringing together a friendly community of racers, fans, and industry professionals. We're all about creating a space where people can connect, share knowledge, and exchange parts and vehicles, with a focus on specific race cars, classes, series, and events. Our community includes all major purpose-built road racing classes, like the Sports Car Club of America (SCCA) and various pro series across North America and beyond. At ApexSpeed, we're passionate about amateur motorsports and are dedicated to helping our community have fun and grow while creating lasting memories on and off the track.
Social